声誉积分: 1
1
Hello! I have replaced the digitizer on an iPad Air, and the top rows of pixels are grey after that. It is about half a centimeter of mostly gray pixels, but below that, the screen works just fine. What can have happened?
Thanks!
声誉积分: 57.5千
18
77
212
Probably didn't connect it properly. Could possibly be a bad part
这个答案有帮助吗？
No, it's connected alright. The digitizer that II installed works just fine, and the LCD is the original. It worked before, but after the replacement it has a grey stripe.
You could try disconnecting the display cables, disconnecting the battery, re-connecting the battery, then re-connecting the display cables. Sometimes this works. It's called cycling the battery
It doesn't seem to work. I will try to avoid disassembling the whole iPad.
Ok, well. I'm going to guess its the part that's the issue. Try using a quality part, like the one I suggested earlier
I only replace the digitizer. The LCD is original. Even when the digitizer is fully disconnected, the gray stripe is still there.
声誉积分: 1
1
1
Your lcd was broken during your digi replacement. That's what they look like (sometimes) when they're broken.
这个答案有帮助吗？
过去 24 小时： 0
过去 7 天： 0
过去 30 天： 1
总计 229
