简介

The Sony Ericsson s710a is a camera phone with all of the features expected of a phone in the mid '00's.

这个拆解是不是维修指南。 要维修你的的Sony Ericsson s710a,请使用我们的服务手册

  1. Remove the back cover by sliding it off.
    • Remove the back cover by sliding it off.

    添加评论

  2. Once the back cover is removed, pull out the battery using your finger as shown.
    • Once the back cover is removed, pull out the battery using your finger as shown.

    添加评论

    • The battery can now be replaced if desired.

      • The battery is a 780 mAh rechargeable Lithium Ion battery.

    添加评论

    • Remove the four 6mm screws behind the battery.

    添加评论

    • Remove plastic piece near the base of the keypad.

      • This will require prying it off with a plastic opening tool and breaking the seal with the glue. Unfortunately there is no way around this.

    • Then remove the two 6mm screws beneath the plastic cover with a Phillips head screw driver.

    • Now you are ready to remove the plastic back cover.

    添加评论

  3. 传播 Fixmas 欢乐
    Get $12 off your purchase of $50 or more with code FIXMAS12
    传播 Fixmas 欢乐
    Get $12 off your purchase of $50 or more with code FIXMAS12
    • Use the plastic opening tool to pry off the back cover of the phone. This will require a bit of careful work.

    • You should start prying the back cover from the SD card slot.

    • Alternate prying the back cover on each side until it pops off.

    添加评论

    • Use the plastic opening tool to carefully pry out the circuit board once you have removed the back cover.

    添加评论

    • Remove the LCD cable connectors coming from through the hinge hole with a flat head screw driver.

    • IMPORTANT: be sure to record which port each cable was in and the orientation they were plugged into each socket.

    • Now the two parts of the phone are separated.

    添加评论

    • On the non-camera side of the phone, remove the four 3mm screws and two 2.3mm screws holding down the twist-structure.

    • When you lift this off, you will need to disconnect the cables from the other side using the same method as in step 5.

    • Again, be sure to record which port each cable was in and the orientation they were plugged into each socket.

    添加评论

    • Remove the plastic piece near the bottom of this side of the phone with the plastic opening tool. This will give you access to two additional screws.

    • Remember you will have to break the glue seal, but that is alright.

    • Remove the four visible 6mm screws and then remove the back cover.

    添加评论

    • In order to remove the LCD screen, use the plastic opening tool to pry the plastic piece from the LCD.

    • Perform this step carefully to avoid scratching the glass screen.

    添加评论

    • In this picture, you can see all of the parts in the non-camera side of the phone.

    • Interestingly, the four control buttons are all one piece

    添加评论

    • This phone has an array of capabilities:

      • Bluetooth

      • Megapixel Camera

      • MP3 capable

      • Messaging options

    • This photograph shows the final result of a complete teardown.

    添加评论

Alexander

于2011年10月29日注册

75 信誉积分

创作了4篇指南

添加评论

浏览统计数据:

过去的24小时: 0

过去的7天: 0

过去的30天: 4

总计 3,852