简介

Complete teardown of Sidekick II

这个拆解是不是维修指南。 要维修你的的Sidekick II,请使用我们的服务手册

  1. Use the plastic opening tool to remove the 4 buttons on each corner of the Sidekick.
    • Use the plastic opening tool to remove the 4 buttons on each corner of the Sidekick.

    • Gently pry open button and remove button.

    • Do this for each of the 3 buttons remaining.

    添加评论

  2. The bumpers on the top and bottom of the phone can be removed by simply "peeling" them off.
    • The bumpers on the top and bottom of the phone can be removed by simply "peeling" them off.

    添加评论

    • Use the Phillips head screwdriver to remove the 4 screws that are underneath the 4 buttons you removed in step one.

    添加评论

    • Flip the screen up halfway (90 degrees), to reveal the 2 screws above the right side of the keyboard.

    • Use the Torx 6 screwdriver to remove these 2 screws.

    • Be careful in handling the phone after removing the screws, because the two main bodies of the phone are no longer attached.

    添加评论

    • After removing the 6 screws and both bumpers, the phone will be easy to separate into the two main bodies.

    • You can use your hands to simply pull apart the top casing from the bottom casing.

    添加评论

    • Remove screen from casing.

    添加评论

    • Remove 4 screws from back of screen using Torx 6 Screwdriver.

    • Pry screen out of casing using fingers.

    添加评论

    • Remove 4 screws from front of screen with Phillip screwdrivers.

    • Peel off the metal covering on the back of the screen.

    • Be careful when taking off the metal covering. The orange ribbon will not come out all the way, and it is fragile.

    添加评论

    • Remove the protective cover in front of the screen.

    • Do not use metal tools, you may damage the protective cover or the screen. Use your fingers only.

    添加评论

    • Take the screws out using the Torx 6 screwdriver.

    • Then lift the thumb wheel and housing off of the front panel.

    添加评论

    • Remove 2 black "rivets" from back of casing with the plastic opening tool.

    • Press keyboard out of front of casing using thumbs. Don't press too hard as you may break the board.

    添加评论

    • Remove the 5 black screws with a Phillips head screwdriver.

    • Lift the bottom of the control board from housing, and separate the two.

    添加评论

    • Carefully remove battery and back plate.

    • Do not use metal tools, you may damage the control board. Use only your fingers.

    添加评论

    • Here are all of the pieces that you have disassembled

    添加评论

michael albaum

于2010年01月20日注册

45 信誉积分

创作了6篇指南

团队

Cal Poly, Team 3-19, Maness Winter 2010 Cal Poly, Team 3-19, Maness Winter 2010 的会员

CPSU-MANESS-W10S3G19

4 名成员

创作了11篇指南

nice job from a former geek

Jared Boies - 回复

添加评论

浏览统计数据:

过去的24小时: 0

过去的7天: 0

过去的30天: 6

总计 6,433