简介

PlayStation 3 super slim - how to fully disassemble.

You can see also: PlayStation 3 Super Slim Teardown


Please SUBSCRIBE to my channel ツ

视频概述

  1. Remove the three rubber feet, warranty sticker and four screws.
    • Remove the three rubber feet, warranty sticker and four screws.

    • Gently pull up on the bottom cover to remove it.

    添加评论

  2. Slide the HDD cover toward the rear of the device to remove it.
    • Slide the HDD cover toward the rear of the device to remove it.

    • Remove the blue screw shown to remove the HDD caddy.

    添加评论

    • Use a metal spudger to push the tab on the rear top finisher, and lift up to remove it.

    添加评论

    • Repeat step 3 for the front top finisher.

    添加评论

  3. 传播 Fixmas 欢乐
    Get $12 off your purchase of $50 or more with code FIXMAS12
    传播 Fixmas 欢乐
    Get $12 off your purchase of $50 or more with code FIXMAS12
    • Remove the two screws indicated in the disk reader.

    • Remove the five screws shown around the edge of the top cover.

    • Lift the top cover up to remove it.

    添加评论

    • Move the optical disk reader assembly to the left to expose one of the screws holding the power supply in.

    • Remove the two screws indicated and carefully disconnect the cable on the right side of the power supply.

    • Lift the power supply up to remove it.

    添加评论

    • Carefully disconnect the ribbon cables indicated.

    • Lift the optical disk reader up to remove it.

    • Disconnect and remove the white cable and ribbon cable indicated.

    添加评论

    • Remove the seven screws indicated.

    • Lift the motherboard assembly up out of the lower half of the case to remove it.

    • Carefully disconnect the Wi-Fi antenna cables and fan connector indicated by red arrows.

    添加评论

    • Remove the six screws indicated to separate the heatsink and shield from the motherboard.

    good job you just broke the ps3 super slim

    korvanjundskyrim - 回复

  4. 添加评论

结论

To reassemble your device, follow these instructions in reverse order.

18等其他人完成本指南。

ZFix

于2013年12月09日注册

160,284 信誉积分

创作了304篇指南

团队

Master Techs Master Techs 的会员

Community

279 名成员

创作了758篇指南

What's the name of the screwdriver that undo's the star shaped screws?

themasterassassin8787 - 回复

It is a T8 Torx screwdriver! I'll add the tools to this guide =)

Sam Lionheart -

i took apart my ps3 super slim and put it back together but there is no power what so ever no red light at all

pastorjon.m - 回复

One thing to pay attention to: The T8 Torx screws (at least on my 500GB model) are Tamper Proof TR8 screws, meaning you need a special screwdriver to undo them. A normal T8 wont work.

Wesley V - 回复

Step 4: “simply remove the front finisher” - are you kidding me? I nearly broke mine!

versluis2000 - 回复

添加评论

浏览统计数据:

过去的24小时: 20

过去的7天: 129

过去的30天: 690

总计 30,126