修复你的物品 社区 商店

修复死亡黄灯

返回指南
英语
中文
上一步 下一步

正翻译步骤 3

步骤 3
Yellow Light of Death Repair: 步骤 0 中的图像 1，1

  • Set the heat gun to "Low" or around 300C (575F), and let it run for a few seconds to reach operating temperature.

  • Holding the motherboard upright, warm up the entire board with the heat gun. The board should be warm, but not too hot.

  • This will prevent damage to the board caused by localized thermal expansion.

将热枪设置为“低”，让其运行几分钟以达到工作温度。

握住主板使之直立，用热枪加热整个主板。 主板会变得暖，但不要使之太热。

这样可以防止局部热膨胀引起的主板损坏。

-[* black] Set the heat gun to "Low", and let it run for a few seconds to reach operating temperature.
+[* black] Set the heat gun to "Low" or around 300C (575F), and let it run for a few seconds to reach operating temperature.
[* black] Holding the motherboard upright, warm up the entire board with the heat gun. The board should be warm, but not too hot.
[* icon_note] This will prevent damage to the board caused by localized thermal expansion.

您的所有投稿皆享有基于开源创作共享许可协议（CC BY-NC-SA）的著作权利。