修复你的物品 社区 商店

iPhone 5s Display Einheit ersetzen

注：你正在编辑的一份前提条件指南。你所做的任何更改将影响包括此步骤的32指南。

返回指南
英语
德语
上一步 下一步

正翻译步骤 10

步骤 10
iPhone 5s Front Panel Assembly Replacement: 步骤 0 中的图像 1，2 iPhone 5s Front Panel Assembly Replacement: 步骤 0 中的图像 2，2

  • During reassembly, you will need to reinstall the Touch ID cable bracket. The top of the bracket needs to slide between the battery and Touch ID cable connector, in front of the metal tab. The bottom must latch down over the connector.

  • Slide the top of the bracket over the Touch ID cable connector from left to right.

  • Alternatively, lay the bracket directly over the connector. The edge with the "leg" will prop the bracket up at a slight angle, and the opposite edge must be between the cable connector and the metal tab near the battery. With the edge of a spudger flat against the bracket, apply gentle downward pressure to snap in the back and front clasps.

Beim Wiederzusammenbau musst du die Touch ID Kabelhalterung wieder einsetzen. Die obere Kante der Halterung muss sich vor die Metalllasche zwischen den Akku und dem Kabelstecker des Touch ID Kabels schieben. Die Unterkante muss über dem Stecker einrasten.

Schiebe die Oberseite von links nach rechts über den Anschluss des Touch ID Kabels.

[* icon_reminder] During reassembly, you will need to reinstall the Touch ID cable bracket. The top of the bracket needs to slide between the battery and Touch ID cable connector, in front of the metal tab. The bottom must latch down over the connector.
[* icon_reminder] Slide the top of the bracket over the Touch ID cable connector from left to right.
+[* icon_note] Alternatively, lay the bracket directly over the connector. The edge with the "leg" will prop the bracket up at a slight angle, and the opposite edge must be between the cable connector and the metal tab near the battery. With the edge of a spudger flat against the bracket, apply gentle downward pressure to snap in the back and front clasps.

您的所有投稿皆享有基于开源创作共享许可协议（CC BY-NC-SA）的著作权利。