Skip to main content
英语
中文

正翻译步骤 6

Step 6
Slide the halberd spudger/opening pick to the upper corner of the phone to cut the adhesive and insert and opening pick to prevent the adhesive from sticking to the display. Go slowly so that the tool doesn't slip out of the seam. If cutting becomes too difficult, reheat and reapply the iOpener. Repeat the previous heating and cutting procedure for the remaining  sides of the phone. Insert an opening pick on every corner and on both sides of the Note8.
  • Slide the halberd spudger/opening pick to the upper corner of the phone to cut the adhesive and insert and opening pick to prevent the adhesive from sticking to the display.

  • Go slowly so that the tool doesn't slip out of the seam. If cutting becomes too difficult, reheat and reapply the iOpener.

  • Repeat the previous heating and cutting procedure for the remaining sides of the phone. Insert an opening pick on every corner and on both sides of the Note8.

  • Use a little extra caution when prying near the top edge so as not to damage the front-facing sensors and earpiece speaker.

将撬棒或三角撬片滑到手机的上角以切割粘合剂并插入三角撬片,防止粘合剂粘在显示屏上。

慢慢来,这样工具就不会滑出接缝。如果切割变得太困难,请重新加热并重新使用 iOpener。

对手机的其它侧面重复之前的加热和切割程序。在Note8的每个角落和两侧插入一个三角撬片。

在顶部边缘附近撬动时要格外小心,以免损坏前置传感器和耳机扬声器。

在开源创作共享许可协议下,你的投稿已被许可