Skip to main content

注:你正在为你刚才查阅的指南编辑前提条件。你所做的任何更改将影响包括此步骤的6本指南

英语
中文

正翻译步骤 2

Step 2
Use a suction handle to lift the back cover and an opening pick to get in the gap. Since the back cover is also slightly curved at the edges you want to insert the opening pick at a lower angle from underneath. Start at the middle of the side and cut the adhesive while pulling up with the suction handle.
  • Use a suction handle to lift the back cover and an opening pick to get in the gap.

  • Since the back cover is also slightly curved at the edges you want to insert the opening pick at a lower angle from underneath.

  • Start at the middle of the side and cut the adhesive while pulling up with the suction handle.

  • Be careful not to lever the opening pick too much to avoid breaking the back cover. Rather pull with the suction handle and use the pick for cutting the adhesive.

  • Move the pick towards the bottom corner and leave it there to keep the adhesive from resealing to the case.

  • Use another pick and move it to the top corner.

  • If it's getting harder to move the pick you might need to reheat the iOpener and apply it to the back cover again.

用一个吸盘来拉开后盖并将一个翘片插到后盖和边框的缝隙里。

因为后盖的边缘也是有一点轻微弯曲的,在插入翘片的时候请保持一个比较低的角度从下插入。

一边拉着吸盘,一边用翘片从侧边中间开始沿着边缘滑动来切开密封胶

小心!不要用翘片将后盖撬的过高,这可能会把你的后盖弄断!用吸盘把后盖拉高再用翘片来切开密封胶。

向手机的底部移动翘片,并把它留在那里(像图2一样)(你肯定不想你刚刚切开的密封胶又双叒叕粘到一起了)

插进另一个翘片,并把它移到手机的顶部(像图3一样)

如果你感觉到越来越难移动你的翘片了,你可能需要用你的iOpener重新加热后盖了。

在开源创作共享许可协议下,你的投稿已被许可