跳转到主内容

修复你的物品

维修的权力

配件 & 工具

简介

Before removing and replacing the sensor of Zoomer Dino Boomer, check the Troubleshooting Page to make sure the issue with gesture mode cannot be fixed without removing the sensor.

  1. Unscrew the two 7.5 mm Phillips #0 screws at the base of the neck. Remove the two 7.2 mm Phillips #0 screws above these at the base of the mouth.
    • Unscrew the two 7.5 mm Phillips #0 screws at the base of the neck.

    • Remove the two 7.2 mm Phillips #0 screws above these at the base of the mouth.

  2. Use the spudger to pry Zoomer Dino Boomer's lower jaw from its mouth. Use the spudger to pry Zoomer Dino Boomer's lower jaw from its mouth.
    • Use the spudger to pry Zoomer Dino Boomer's lower jaw from its mouth.

  3. 任天堂 Switch 套装

    快速恢复到游戏的状态

    购买 Switch 套装

    任天堂 Switch 套装

    快速恢复到游戏的状态

    购买 Switch 套装
  4. Remove the roof of Zoomer Dino Boomer's mouth by unscrewing the 7.5 mm Phillips #0 screw. Remove the roof of Zoomer Dino Boomer's mouth by unscrewing the 7.5 mm Phillips #0 screw.
    • Remove the roof of Zoomer Dino Boomer's mouth by unscrewing the 7.5 mm Phillips #0 screw.

  5. Carefully push the sensors out of the nose socket with your fingers. Carefully push the sensors out of the nose socket with your fingers.
    • Carefully push the sensors out of the nose socket with your fingers.

  6. Use a soldering iron to remove the wires from the sensor chip by melting the metal joints on the chip. Use the tweezers to remove the wires as you are soldering them. Do not touch any parts of Zoomer Dino Boomer or yourself when using the soldering iron. The soldering iron will be very hot.
    • Use a soldering iron to remove the wires from the sensor chip by melting the metal joints on the chip.

    • Use the tweezers to remove the wires as you are soldering them.

    • Do not touch any parts of Zoomer Dino Boomer or yourself when using the soldering iron. The soldering iron will be very hot.

    • When reassembling, extra solder may be required to reconnect the wires with the circuit board.

  7. Remove and replace the nose sensor.
    • Remove and replace the nose sensor.

结论

To reassemble your device, follow these instructions in reverse order.

Lauren Mannix

于2015年08月29日注册

392 信誉积分

创作了3篇指南

团队

USF Tampa, Team 16-1, Wollert Fall 2015 USF Tampa, Team 16-1, Wollert Fall 2015 的会员

USFT-WOLLERT-F15S16G1

3 名成员

创作了5篇指南

添加评论

浏览统计数据:

过去的24小时: 0

过去的7天: 4

过去的30天: 11

总计 953