跳转到主内容

简介

This is a guide for replacing the motherboard of your Zeki device. To reach the motherboard, first remove the plastic backing. Then, the battery, and camera. After replacing the motherboard, the device will need to be reassembled in the opposite order.

工具

没有特定工具。

  1. Remove the two screws from the end of the device where the ports are located. Remove the two screws from the end of the device where the ports are located.
    • Remove the two screws from the end of the device where the ports are located.

  2. Rest the tablet on the glass face.
    • Rest the tablet on the glass face.

    • Insert the tip of a plastic opening tool into the small gap, between the grey and white plastic. Pry it open, (you should hear the clips opening up).

    • Gently work your way around the perimeter of the tablet's edge.

  3. Separate the back and face plates. Remove any tape on the speaker, and detach the speaker from the back plate.
    • Separate the back and face plates.

    • Remove any tape on the speaker, and detach the speaker from the back plate.

    • The speaker is connected to the motherboard by two soldered wires. Don't break them when you remove the speaker.

  4. Remove the Wi-Fi antenna element, which is highlighted by red in the picture,  from the front plate.
    • Remove the Wi-Fi antenna element, which is highlighted by red in the picture, from the front plate.

  5. Use the same screw driver as the previous step, and unscrew three screws. (Circled in the figure.)
    • Use the same screw driver as the previous step, and unscrew three screws. (Circled in the figure.)

  6. Open the ZIF connector. It will look like a black locker, covering a wire ribbon. Then, remove the wire ribbon that connects the motherboard, and the screen.
    • Open the ZIF connector. It will look like a black locker, covering a wire ribbon. Then, remove the wire ribbon that connects the motherboard, and the screen.

  7. Remove the other wire ribbon on the opposite side of the motherboard.
    • Remove the other wire ribbon on the opposite side of the motherboard.

  8. Now, remove the motherboard and replace it with a new one.
    • Now, remove the motherboard and replace it with a new one.

    • Be careful not to damage the battery, or the speaker wires. They are soldered onto the motherboard.

结论

To reassemble your device, follow these instructions in reverse order.

2等其他人完成本指南。

Linlin Cai

于2015年09月16日注册

317 信誉积分

撰写一个指南

团队

IUPUI, Team 1-3, Harley Fall 2015 IUPUI, Team 1-3, Harley Fall 2015 的会员

IUPUI-HARLEY-F15S1G3

5 名成员

创作了5篇指南

添加评论

浏览统计数据:

过去的24小时: 0

过去的7天: 1

过去的30天: 10

总计 377