修复你的物品 社区 商店

VTech CS6719-2 Charging Wire Repair

简介

During this guide, the base will need to be disassembled and then desolder the charging wire connections.

你所需要的

  1. VTech CS6719-2 Charging Wire Repair, Base: 步骤 1 中的图像 1，2 VTech CS6719-2 Charging Wire Repair, Base: 步骤 1 中的图像 2，2

    • Remove the four Phillips #0 screws (9.4mm) located at the bottom of the phone on the back side of the base.

    编辑

  2. VTech CS6719-2 Charging Wire Repair: 步骤 2 中的图像 1，1

    • Use the spudger to separate the bottom from the top.

    • There are two clips, located top and bottom, that you have to compress with the spudger.

    编辑

  4. VTech CS6719-2 Charging Wire Repair, Charging Wire: 步骤 3 中的图像 1，1

    • Heat up solder joint on the circuit board where the charging wires are connected. Note: This is the CRD- and CRD+ terminals.

    编辑

  5. VTech CS6719-2 Charging Wire Repair: 步骤 4 中的图像 1，1

    • Refer to How to Solder and Desolder connections 如何焊接和拆焊

    • Note: Ensure the old solder joint is removed.

    • Caution: Soldering iron and joint will become very hot.

    编辑

  6. VTech CS6719-2 Charging Wire Repair: 步骤 5 中的图像 1，1

    • Heat up solder joint on the base unit where the charging wires are connected.

    编辑

  7. VTech CS6719-2 Charging Wire Repair: 步骤 6 中的图像 1，1

    • Take a wire of solder and apply to joint on board to remove the extra solder.

    • Note: Ensure the old solder joint is removed.

    • Caution: Soldering iron and joint will become very hot.

    • Remove charging wire connection.

    编辑
结论

To reassemble your device, follow these instructions in reverse order.

另外一个人完成了本指南。

作者

与2其他贡献者

Josh Showalter

于02/08/16注册

442 声望

创作了3篇指南

徽章: 15

+ 12更多徽章

团队

IUPUI, Team 1-4, Baechle Spring 2016 IUPUI, Team 1-4, Baechle Spring 2016 的会员

IUPUI-BAECHLE-S16S1G4

4 名成员

创作了16篇指南

0条评论

添加评论

浏览统计数据:

过去 24 小时： 1

过去 7 天： 2

过去 30 天： 5

总计 1,365