Teenage Engineering OP-Z Rubber Feet Replacement - iFixit 维修指南

简介

Use this guide to replace the rubber feet of your OP-Z.

你所需要的

步骤 1 Back Cover

Teenage Engineering OP-Z Rubber Feet Replacement, Back Cover: 步骤 1 中的图像 1，3

Teenage Engineering OP-Z Rubber Feet Replacement, Back Cover: 步骤 1 中的图像 2，3

Teenage Engineering OP-Z Rubber Feet Replacement, Back Cover: 步骤 1 中的图像 3，3

Unlock the four rubber feet by turning them 90° counterclockwise using your thumb or finger tip.
There is a tiny mark on every foot facing the bottom edge of the OP-Z. After turning them they should face towards the short edge where the on/off switch is.

步骤 2

Teenage Engineering OP-Z Rubber Feet Replacement: 步骤 2 中的图像 1，2

Teenage Engineering OP-Z Rubber Feet Replacement: 步骤 2 中的图像 2，2

When turning the OP-Z over again the bottom plate should come off by itself (thanks gravity).
If the bottom plate won’t come off you might want to make sure every foot is rotated correctly and gently tug on one of them.

步骤 3

Teenage Engineering OP-Z Rubber Feet Replacement: 步骤 3 中的图像 1，1

Remove the bottom plate including the rubber feet.

步骤 4 Rubber Feet

Teenage Engineering OP-Z Rubber Feet Replacement, Rubber Feet: 步骤 4 中的图像 1，1

Remove the four Phillips #0 screws from the back of the rubber feet.

步骤 5

Teenage Engineering OP-Z Rubber Feet Replacement: 步骤 5 中的图像 1，2

Teenage Engineering OP-Z Rubber Feet Replacement: 步骤 5 中的图像 2，2

Separate the front and rear part of the rubber feet from the back cover.

步骤 6

Teenage Engineering OP-Z Rubber Feet Replacement: 步骤 6 中的图像 1，1

When reassembling make sure to correctly align the front and rear part of the rubber feet. The notch and grove should interlock and fit into the cutout of the back cover.

结论

To reassemble your device, follow these instructions in reverse order.

作者

与1其他贡献者

Tobias Isakeit

于03/31/14注册

117,750 声望

创作了188篇指南

+ 43更多徽章

团队

Master Techs Master Techs 的会员

Community

322 名成员

创作了2,541篇指南

0条评论

浏览统计数据:

过去 24 小时： 0

过去 7 天： 8

过去 30 天： 23

总计 1,594