修复你的物品 社区 商店

TaoTronics TT-SK06 Aux Port Replacement

简介

Replace the aux port on your device

你所需要的

  1. TaoTronics TT-SK06 Aux Port Replacement, Front Grate: 步骤 1 中的图像 1，2 TaoTronics TT-SK06 Aux Port Replacement, Front Grate: 步骤 1 中的图像 2，2

    • To remove the front grate of the speaker grab a metal spudger and go to the back corner of the device where the front panel curves around the device. Insert the spudger and ply apart the corner until clips release from panel. Repeat for the other side of the grate. When all clips are released pull grate off from the front of device

    • When working with electronics, it's important to choose a tool that's ESD-safe to avoid accidental damage to the device. The metal spudger is great when you need serious prying power, but the regular black nylon spudger or a plastic opening tool should be used whenever possible.

    编辑

  2. TaoTronics TT-SK06 Aux Port Replacement: 步骤 2 中的图像 1，3 TaoTronics TT-SK06 Aux Port Replacement: 步骤 2 中的图像 2，3 TaoTronics TT-SK06 Aux Port Replacement: 步骤 2 中的图像 3，3

    • Grab two metal spudgers and insert one into the slit underneath the silver plating on the top of the device. Pry upward with the spudger until you unhook the two locks on the top. Repeat same step for the bottom of the device. When all four tabs are released, slide device out of the casing

    • Use caution when working with the metal spudger, as it can potentially damage your device.

    编辑

  4. TaoTronics TT-SK06 Aux Port Replacement, Aux Port: 步骤 3 中的图像 1，1

    • Remove the circuit board containing the aux port using the tweezers.

    编辑

  5. TaoTronics TT-SK06 Aux Port Replacement: 步骤 4 中的图像 1，1

    • Remove the aux port from the board by un-soldering the connection points.

    • To reattach, solder aux port back onto board. For soldering help, check out iFixit's How to Solder and Desolder Connections guide.

    编辑
结论

To reassemble your device, follow these instructions in reverse order.

2等其他人完成本指南。

作者

与2其他贡献者

Niko Fabian

于03/06/16注册

715 声望

创作了5篇指南

徽章: 9

+ 6更多徽章

团队

UMass Dartmouth, Team 5-7, Landers Spring 2016 UMass Dartmouth, Team 5-7, Landers Spring 2016 的会员

UMASSD-LANDERS-S16S5G7

3 名成员

创作了5篇指南

一条评论

I wanted to completely disassemble the speaker to see if I could modify its power source (from battery to USB). but found it glued shut. There are screws that would seem to open up the internals, but removing the screws did nothing. In the end I put it back together, and decided to not replace any of the screws. The glue and metal case are sufficient. No screws necessary.

I would prefer it to not power down while using USB power, but destroying the speaker to convert it to USB power is not the answer.

Michael Johnstone - 回复

添加评论

浏览统计数据:

过去 24 小时： 0

过去 7 天： 2

过去 30 天： 7

总计 1,782