跳转到主内容

简介

Replacement guide for the digitizer on a Samsung Galaxy Tab 4 10.1 android tablet.

  1. Insert the wedge of the nylon spudger and slide it between the front and back panels until the back comes off. Insert the wedge of the nylon spudger and slide it between the front and back panels until the back comes off.
    • Insert the wedge of the nylon spudger and slide it between the front and back panels until the back comes off.

  2. Peel off the green tape that covers the connectors for the three black strips.
    • Peel off the green tape that covers the connectors for the three black strips.

    • Use the tip of a spudger or your fingernail to flip up the small retaining flaps.

  3. Use a Phillips #00  screwdriver to remove the four 3.2mm  screws.
    • Use a Phillips #00 screwdriver to remove the four 3.2mm screws.

  4. Detach the red, blue, and black cables by prying up on the white connector from the motherboard.
    • Detach the red, blue, and black cables by prying up on the white connector from the motherboard.

    • If using fingers instead, pull evenly on the full width of the cable so the wires are not overly strained.

    • If you pull too hard you can damage the connector on the circuit board. Use a spudger or tweezers to push down on the black connector on the board while gently prying the battery connector loose. The connector breaks VERY easily.

  5. Macbook 电池维修套装

    起价 $69.99

    Buy Now

    Macbook 电池维修套装

    起价 $69.99

    Buy Now
  6. Use the nylon spudger to remove the battery by prying up on the edges.
    • Use the nylon spudger to remove the battery by prying up on the edges.

  7. Once the battery is loose,  lift it out of the device.
    • Once the battery is loose, lift it out of the device.

  8. Use the flat end of a spudger to disconnect the home button.
    • Use the flat end of a spudger to disconnect the home button.

  9. Use an iOpener to weaken the adhesive around the display.
    • Use an iOpener to weaken the adhesive around the display.

  10. Wedge an opening pick between the digitizer and display frame.
    • Wedge an opening pick between the digitizer and display frame.

    • Slide the opening pick around the perimeter to separate the two pieces.

  11. Lift and remove the digitizer. Lift and remove the digitizer.
    • Lift and remove the digitizer.

结论

To reassemble your device, follow these instructions in reverse order.

另外一个人完成了本指南。

Blake Klein

于2017年01月29日注册

44,151 信誉积分

创作了48篇指南

添加评论

浏览统计数据:

过去的24小时: 4

过去的7天: 18

过去的30天: 121

总计 1,201