跳转到主内容

RCA Pro10 Edition Power/Volume Buttons Replacement

你所需要的

  1. RCA Pro10 Edition Power/Volume Buttons Replacement, Speaker: 步骤 1 中的图像 1,2 RCA Pro10 Edition Power/Volume Buttons Replacement, Speaker: 步骤 1 中的图像 2,2
    • Using a separating tool, look for a seam in the plastic casing that looks most accessible.

    • Use the prying tool to separate the front and back casing, working your way around the perimeter.

    • Utilize a card tool or a pick to assist in keeping the case separated.

    • To reassemble the device simply align the two casing halves and pinch to snap together or press down on the edges while the device in on a table.

  2. RCA Pro10 Edition Power/Volume Buttons Replacement: 步骤 2 中的图像 1,1
    • Flip over the back of the device while keeping it close to the front, the speaker is attached to it.

    • Remove the yellow tape securing the speaker to the back casing.

  3. RCA Pro10 Edition Power/Volume Buttons Replacement: 步骤 3 中的图像 1,2 RCA Pro10 Edition Power/Volume Buttons Replacement: 步骤 3 中的图像 2,2
    • Use the separating tool to pry the speaker from its surface.

    • Use caution when removing the speaker, you may damage the screen.

    • Cut or desolder the wires to replace or repair the speaker.

  4. RCA Pro10 Edition Power/Volume Buttons Replacement, Camera: 步骤 4 中的图像 1,3 RCA Pro10 Edition Power/Volume Buttons Replacement, Camera: 步骤 4 中的图像 2,3 RCA Pro10 Edition Power/Volume Buttons Replacement, Camera: 步骤 4 中的图像 3,3
    • Using a P00 Phillips screwdriver, remove the three screws securing the black plastic camera housing and remove it.

    • Peel back the beige tape while holding down the camera ribbon cable to prevent tears

  5. RCA Pro10 Edition Power/Volume Buttons Replacement: 步骤 5 中的图像 1,2 RCA Pro10 Edition Power/Volume Buttons Replacement: 步骤 5 中的图像 2,2
    • Lift the locking tab that is securing the camera ribbon cable.

    • Slide the ribbon cable out from the connector and remove from casing.

  6. RCA Pro10 Edition Power/Volume Buttons Replacement, Power/Volume Buttons: 步骤 6 中的图像 1,1
    • Use a P00 Phillips screwdriver to remove the three screws securing the button board.

    • Desolder the contacts on the button board to remove or replace it.

结论

To reassemble your device, follow these instructions in reverse order.

Dayne Russell

于01/27/15注册

401 声望

创作了4篇指南

团队

Pasco Hernando, Team 1-1, Prince Winter 2015 Pasco Hernando, Team 1-1, Prince Winter 2015 的会员

PHSC-PRINCE-W15S1G1

6 名成员

创作了10篇指南

一条评论

What is the part number for the Power/Volume Buttons? Where can I purchase one?

EvanSnow - 回复

添加评论

浏览统计数据:

过去 24 小时: 0

过去 7 天: 0

过去 30 天: 1

总计 979