修复你的物品 社区 商店

Protocol TerraCopter EVO Drone Motor Replacement

你所需要的

  1. Protocol TerraCopter EVO Drone Motor Replacement, Drone Motor: 步骤 1 中的图像 1，1

    • Orientate the drone to where the black side of the drone face upwards.

    • On the bottom side of the drone, remove the twenty-two 5mm Phillips #1 screws holding the black frame to the body.

    • There is one screw under the rear light. Pry the opaque cover to access the last screw.

    编辑

  2. Protocol TerraCopter EVO Drone Motor Replacement: 步骤 2 中的图像 1，1

    • The plastic frames are subject to cracking.

    • Wires run through both frames.

    • Pry the white body away from the black frame.

    编辑

  4. Protocol TerraCopter EVO Drone Motor Replacement: 步骤 3 中的图像 1，1

    • Gently pry the motor from it's socket.

    编辑

  5. Protocol TerraCopter EVO Drone Motor Replacement: 步骤 4 中的图像 1，2 Protocol TerraCopter EVO Drone Motor Replacement: 步骤 4 中的图像 2，2

    • Locate these solder points of the leads on the motherboard.

    • From the front of the drone, the left motor has red and blue leads.

    • From the front of the drone, the right motor has white and black leads.

    • Remove the leads from their points on the motherboard with a soldering iron, respective to each motor.

    • Check out our How to Solder and Desolder Connections guide if you are unfamiliar with soldering practices.

    编辑
结论

To reassemble your device, follow these instructions in reverse order.

0条评论

添加评论

浏览统计数据:

过去 24 小时： 0

过去 7 天： 1

过去 30 天： 1

总计 190