跳转到主内容

本指南有最近更改,您可查看未经巡查的最新版本

PSP Go Headphone Jack Replacement

你所需要的

  1. PSP Go Headphone Jack Replacement, Back Cover: 步骤 1 中的图像 1,2 PSP Go Headphone Jack Replacement, Back Cover: 步骤 1 中的图像 2,2
    • Unscrew the four Phillips screws on the back of the PSP Go.

    • Rotate the PSP so you can see the top of the device.

    • Unscrew the two Phillips screws next to the volume buttons.

  2. PSP Go Headphone Jack Replacement: 步骤 2 中的图像 1,2 PSP Go Headphone Jack Replacement: 步骤 2 中的图像 2,2
    • Use a plastic opening tool around the perimeter of the back cover to loosen it on all sides.

    • Open the back cover by gently lifting the right side, and rotating it to the left side (as if you were opening a book).

    • Be careful not to rotate the back cover from the bottom, as you will break the plastic screw holes on top of the device.

  3. PSP Go Headphone Jack Replacement, Top Cover: 步骤 3 中的图像 1,1
    • Pull the top cover upwards gently from its housing.

  4. PSP Go Headphone Jack Replacement, Bottom Plate: 步骤 4 中的图像 1,2 PSP Go Headphone Jack Replacement, Bottom Plate: 步骤 4 中的图像 2,2
    • Remove the two Phillips screws holding the bottom plate.

    • Gently lift the bottom plate away from the device.

  5. PSP Go Headphone Jack Replacement, Headphone Jack: 步骤 5 中的图像 1,1
    • Remove the black Phillips screw holding the headphone jack in place.

  6. PSP Go Headphone Jack Replacement: 步骤 6 中的图像 1,1
    • Use a pair of tweezers and grasp the black plastic portion of the headphone jack cable.

    • Slowly pull out the cable. If it's hard to pull, wiggle it slightly side-to-side while pulling it.

    • Plugging the new headphone jack into place will require some force. Make sure not to break the connector while performing this procedure. Grasp the black plastic portion of the cable and wiggle it into the logic board connector.

结论

To reassemble your device, follow these instructions in reverse order.

2等其他人完成本指南。

0条评论

添加评论

浏览统计数据:

过去 24 小时: 1

过去 7 天: 4

过去 30 天: 15

总计 10,543