简介

Steps for removing the motherboard of a Sony PSP-3000

Place the PSP face down and locate the battery cover on the left side of the device. Lift and remove the battery cover to reveal the battery. Remove the battery.
  • Place the PSP face down and locate the battery cover on the left side of the device.

  • Lift and remove the battery cover to reveal the battery.

  • Remove the battery.

添加评论

Peel back the warranty sticker that is behind the battery with a spudger or your fingernail.
  • Peel back the warranty sticker that is behind the battery with a spudger or your fingernail.

添加评论

Unscrew all four screws from the back of the PSP with the Phillips #00 Screwdriver. Two are located behind the battery's warranty sticker.
  • Unscrew all four screws from the back of the PSP with the Phillips #00 Screwdriver.

    • Two are located behind the battery's warranty sticker.

    • Two are located on the right side of the PSP.

添加评论

Next, unscrew the two screws located at the top of the PSP.
  • Next, unscrew the two screws located at the top of the PSP.

添加评论

Then, remove the single screw from the bottom edge of the PSP (which is positioned next to the barcode).
  • Then, remove the single screw from the bottom edge of the PSP (which is positioned next to the barcode).

添加评论

Slide the spudger in between the outer casing of the PSP, beginning at the "R" shoulder button, and gently pry off the casing.
 Remove the front casing completely.
  • Slide the spudger in between the outer casing of the PSP, beginning at the "R" shoulder button, and gently pry off the casing.


  • Remove the front casing completely.

添加评论

Push the homebar to the right to release the tab located on the right side of the LCD screen.
  • Push the homebar to the right to release the tab located on the right side of the LCD screen.

  • DO NOT completely remove the homebar, as it is still connected by ribbon cables.

添加评论

Slowly lift the LCD screen off the PSP starting at the top edge corner. Again, the LCD screen is attached by ribbon cables, so do not remove it completely.
  • Slowly lift the LCD screen off the PSP starting at the top edge corner.

  • Again, the LCD screen is attached by ribbon cables, so do not remove it completely.

    • Orientation of PSP is flipped in photo.

添加评论

Flip the small brown locks on the four ribbon cable connectors up using a spudger or fingernail. Pull all four ribbon cables out.
  • Flip the small brown locks on the four ribbon cable connectors up using a spudger or fingernail.

  • Pull all four ribbon cables out.

  • Now remove the LCD screen and homebar from the PSP.

添加评论

Remove the metal tab that lies above the LCD screen.
  • Remove the metal tab that lies above the LCD screen.

  • Upon reassembly, make note that the stamped lettering faces down, and the large tab fits just above the motherboard to the right hand side of the left trigger.

添加评论

Remove the screw securing 'L' trigger to the PSP.
  • Remove the screw securing 'L' trigger to the PSP.

添加评论

Remove the white plastic piece that holds the 'L' trigger in place.
  • Remove the white plastic piece that holds the 'L' trigger in place.

添加评论

Remove the 'L' trigger from the PSP.
  • Remove the 'L' trigger from the PSP.

添加评论

Remove the screw securing the 'R' trigger.
  • Remove the screw securing the 'R' trigger.

添加评论

Remove the white plastic piece that holds the 'R' trigger in place.
  • Remove the white plastic piece that holds the 'R' trigger in place.

添加评论

Remove the 'R' trigger from the PSP.
  • Remove the 'R' trigger from the PSP.

添加评论

Remove the screw from the bottom left edge of the PSP.
  • Remove the screw from the bottom left edge of the PSP.

添加评论

Being careful not to break the ribbon cable, use the spudger to peel the adhesive button of the the 'L' trigger off the PSP.
  • Being careful not to break the ribbon cable, use the spudger to peel the adhesive button of the the 'L' trigger off the PSP.

Being careful not to break the ribbon cable, use the spudger to peel the adhesive button of the 'L' trigger off the PSP.

buzinon - 回复

Using a fingernail or spudger, flip up the retaining bracket on the d-pad and 'L' trigger ribbon cable. Lift the black plastic bracket along with the d-pad contact pad, disconnecting the ribbon cable as you lift.
  • Using a fingernail or spudger, flip up the retaining bracket on the d-pad and 'L' trigger ribbon cable.

  • Lift the black plastic bracket along with the d-pad contact pad, disconnecting the ribbon cable as you lift.

添加评论

Remove the cable from the connector and remove the entire black piece from the PSP.
  • Remove the cable from the connector and remove the entire black piece from the PSP.

添加评论

Remove the screw holding the analog stick in place.
  • Remove the screw holding the analog stick in place.

添加评论

Flip up the lock on the analog sticks ribbon cable. Remove the analog stick from the PSP.
  • Flip up the lock on the analog sticks ribbon cable.

  • Remove the analog stick from the PSP.

添加评论

After removing the LCD Screen, the Button Pad should be easy to remove.
  • After removing the LCD Screen, the Button Pad should be easy to remove.

添加评论

Flip up the lock and detach the ribbon cable above the power jack.
  • Flip up the lock and detach the ribbon cable above the power jack.

添加评论

Remove the screw from the power jack.
  • Remove the screw from the power jack.

添加评论

Carefully bend back the black tab holding the power jack in place and start pulling the jack up to release it from this clip.
  • Carefully bend back the black tab holding the power jack in place and start pulling the jack up to release it from this clip.

添加评论

Pull the plug connecting the power jack to the motherboard.
  • Pull the plug connecting the power jack to the motherboard.

  • Remove the power jack.

添加评论

Push the black tab at the bottom of the speaker to pop the speaker out of place, and remove the speaker. The speaker is spring loaded, so be sure to keep an eye on it in case it starts doing flips into the air when you push the tab.  Be careful not to lose or damage it!
  • Push the black tab at the bottom of the speaker to pop the speaker out of place, and remove the speaker.

    • The speaker is spring loaded, so be sure to keep an eye on it in case it starts doing flips into the air when you push the tab. Be careful not to lose or damage it!

    • Make sure the new/replacement speaker does not spring out during reassembly.

添加评论

Unplug the wireless cable.
  • Unplug the wireless cable.

添加评论

Flip up the locks and remove the two ribbon cables shown.
  • Flip up the locks and remove the two ribbon cables shown.

添加评论

Flip up the lock and remove one last ribbon cable from the bottom edge of the PSP.
  • Flip up the lock and remove one last ribbon cable from the bottom edge of the PSP.

添加评论

Remove the screw from the bottom left corner of the PSP.
  • Remove the screw from the bottom left corner of the PSP.

添加评论

Remove the screw from the top of the power switch panel. Gently remove panel from pegs starting from switch side. Remove the screw from the top of the power switch panel. Gently remove panel from pegs starting from switch side. Remove the screw from the top of the power switch panel. Gently remove panel from pegs starting from switch side.
  • Remove the screw from the top of the power switch panel. Gently remove panel from pegs starting from switch side.

添加评论

Lift the silver rim on the right side of the PSP up and off.
  • Lift the silver rim on the right side of the PSP up and off.

添加评论

Lift the silver rim on the left side of the PSP up and off.
  • Lift the silver rim on the left side of the PSP up and off.

添加评论

Lift the motherboard up slowly starting from the bottom of the PSP, being careful not to damage the port on top.
  • Lift the motherboard up slowly starting from the bottom of the PSP, being careful not to damage the port on top.

添加评论

Pull the motherboard out and remove it from the PSP. Pull the motherboard out and remove it from the PSP.
  • Pull the motherboard out and remove it from the PSP.

添加评论

结论

To reassemble your device, follow these instructions in reverse order.

9等其他人完成本指南。

mbnewsom

于2009年10月28日注册

2,357 信誉积分

创作了11篇指南

添加评论

浏览统计数据:

过去的24小时: 4

过去的7天: 33

过去的30天: 187

总计 27,045