跳转到主内容

本指南有最近更改,您可查看未经巡查的最新版本

Motherboard

你所需要的

  1. Motherboard, Battery: 步骤 1 中的图像 1,1
    • Flip over the phone so that the back is facing up.

    • Pressing your thumb against the back cover, slide the cover off of the phone.

  2. Motherboard: 步骤 2 中的图像 1,1
    • Remove the phone's battery.

  3. Motherboard, Motherboard: 步骤 3 中的图像 1,2 Motherboard, Motherboard: 步骤 3 中的图像 2,2
    • Use a plastic opening tool to pry out the two tabs on the top corners of the battery compartment.

  4. Motherboard: 步骤 4 中的图像 1,1
    • Gently pull off hinge cap piece from the the top of the phone.

  5. Motherboard: 步骤 5 中的图像 1,1
    • Using a T6 Torx Screwdriver, remove the four 7.62mm screws around the corners of the battery compartment.

  6. Motherboard: 步骤 6 中的图像 1,2 Motherboard: 步骤 6 中的图像 2,2
    • Open the phone and turn it on its side.

    • Using a plastic opening tool, run along the seam located around the sides of the phone to pop the clips holding the casing to the frame.

  7. Motherboard: 步骤 7 中的图像 1,1
    • Using your hand, gently pull of the back panel from the bottom half of the phone.

  8. Motherboard: 步骤 8 中的图像 1,1
    • Close the phone and place it on a flat surface.

    • Using a plastic opening tool or your finger, lift up the motherboard from the bottom casing.

    • Be careful when pulling up the board, as there is still a ribbon cable attached to the back of the board.

  9. Motherboard: 步骤 9 中的图像 1,1
    • On the underside of the motherboard, find the ribbon cable that attaches the board to the rest of the phone.

    • Using a plastic opening tool, slowly detach the ribbon cable connector, then pull the motherboard away from the frame.

结论

To reassemble your device, follow these instructions in reverse order.

2等其他人完成本指南。

Andrew

于10/04/10注册

397 声望

创作了4篇指南

团队

Cal Poly, Team 4-46, Amido Fall 2010 Cal Poly, Team 4-46, Amido Fall 2010 的会员

CPSU-AMIDO-F10S4G46

4 名成员

创作了14篇指南

0条评论

添加评论

浏览统计数据:

过去 24 小时: 0

过去 7 天: 0

过去 30 天: 2

总计 454