当前版本的文档还未经巡查,您可以查看最新的已查核版本。
这个步骤还没有翻译 帮忙翻译一下
Flip over the phone so that the back is facing up.
Pressing your thumb against the back cover, slide the cover off of the phone.
Remove the phone's battery.
Use the iFixit opening tool to pry out the two tabs at the top corners of the battery compartment.
Gently pull off the hinge cap from the top of the phone by hand.
Use a T6 Torx screwdriver to remove the four 7.6 mm screws at the corners of the battery compartment.
Open the phone and turn it on its side. You will see a seam around the Nokia’s side.
Use the iFixit opening tool to run along this seam to pop the clips holding the casing to the frame.
Use your hand to gently pull off the back panel from the bottom half of the phone.
Close the phone and place it on a flat surface.
Use the plastic opening tool or your finger to lift up the motherboard from the bottom casing.
Be careful when pulling up the board; there is still a ribbon cable attached to the back of the board.
Find the underside of the motherboard and locate the ribbon cable that attaches the board to the rest of the phone. Use the plastic opening tool to slowly detach the ribbon cable connector, then pull the motherboard away from the frame.
取消:我没有完成这个指南。
2等其他人完成本指南。
与9其他贡献者
于10/04/10注册
397 声望
创作了4篇指南
徽章: 8
+ 5更多徽章
CPSU-AMIDO-F10S4G46
4 名成员
创作了14篇指南
选择一个尺寸并复制下面的代码,将本指南作为一个小插件嵌入到你的网站/论坛中。
过去 24 小时: 1
过去 7 天: 4
过去 30 天: 15
总计 467