修复你的物品 社区 商店

Microsoft Surface Pro Display Replacement

简介

Use this guide to replace a broken display on a Microsoft Surface Pro, or to remove the display for further repairs.

你所需要的

  1. Microsoft Surface Pro Display Replacement, Heat edges of display: 步骤 1 中的图像 1，1

    • Use a heated iOpener or a heat gun to heat the edges of the display and soften its adhesive.

    • If you're using an iOpener it may take several cycles of reheating and applying it to soften the adhesive enough. Every time, let the iOpener sit on the display for at least a minute before reheating to allow the adhesive to soften.

    编辑

  2. Microsoft Surface Pro Display Replacement, Lift display and cut adhesive: 步骤 2 中的图像 1，3 Microsoft Surface Pro Display Replacement, Lift display and cut adhesive: 步骤 2 中的图像 2，3 Microsoft Surface Pro Display Replacement, Lift display and cut adhesive: 步骤 2 中的图像 3，3

    • Apply a suction cup as close as possible to the edge of the display.

    • Use the suction cup to lift the edge of the display enough to insert an opening pick under the edge.

    • Slide the opening pick all the way around the edges of the display to cut through the adhesive on the bezel.

    • Do not insert the opening pick past the bezel of the display—you may permanently damage the display.

    • The bezel is much thinner on the bottom of the display, which is the side with the Windows logo. To avoid damage, don't poke too deep with the opening pick on the bottom edge.

    • Ribbon cables and a circuit board are approx. 0.6 cm from the edge of the glass.

    • Be very careful and move slowly during this step. The display is fragile and will crack if too much force is applied against it. If your tools seem stuck, apply more heat to further soften the adhesive.

    编辑

  4. Microsoft Surface Pro Display Replacement, Disconnect/peel off ribbon cables: 步骤 3 中的图像 1，3 Microsoft Surface Pro Display Replacement, Disconnect/peel off ribbon cables: 步骤 3 中的图像 2，3 Microsoft Surface Pro Display Replacement, Disconnect/peel off ribbon cables: 步骤 3 中的图像 3，3

    • Starting from the top edge, lift the display slightly.

    • If you feel any resistance, use heat and an opening pick to slice through any remaining adhesive.

    • Before completely removing the display:

    • Disconnect the three display cables.

    • Gently peel from the frame 2 orange ribbon cables that are glued to it, as those should stay with the display. (e.g. use a thin plastic card to separate them)

    编辑

  5. Microsoft Surface Pro Display Replacement, Removal: 步骤 4 中的图像 1，1

    • Remove the display.

    编辑
结论

To reassemble your device, follow these instructions in reverse order.

3等其他人完成本指南。

作者

与3其他贡献者

Adam O'Camb

于04/11/15注册

199,443 声望

创作了416篇指南

徽章: 39

+ 36更多徽章

0条评论

添加评论

浏览统计数据:

过去 24 小时： 2

过去 7 天： 34

过去 30 天： 134

总计 8,334