修复你的物品 社区 商店

MiTM Pressure Washer CM1400HDEC1 2017 Motor Assembly Replacement

简介

Follow the steps in this guide to remove and replace the motor/pump assembly of a Mi-T-M CM1400HDEC1 electric pressure washer.

你所需要的

  1. MiTM Pressure Washer CM1400HDEC1 2017 Motor Assembly Replacement, Disconnect all hoses and unplug the power cord: 步骤 1 中的图像 1，2 MiTM Pressure Washer CM1400HDEC1 2017 Motor Assembly Replacement, Disconnect all hoses and unplug the power cord: 步骤 1 中的图像 2，2

    • Disconnect all hoses and unplug the power cord before performing any repairs on the Mi-T-M electric pressure washer.

    编辑

  2. MiTM Pressure Washer CM1400HDEC1 2017 Motor Assembly Replacement, Remove four hex bolts: 步骤 2 中的图像 1，2 MiTM Pressure Washer CM1400HDEC1 2017 Motor Assembly Replacement, Remove four hex bolts: 步骤 2 中的图像 2，2

    • Use a socket wrench to remove the four 47.9 mm-long 11 mm hex head bolts holding the motor in place from the bottom of the frame assembly.

    • Only remove these bolts while the pressure washer is in an upright position.

    • You will likely need an additional 11 mm wrench to hold the nuts on top of the stacks in place as you loosen the bolts.

    编辑

  4. MiTM Pressure Washer CM1400HDEC1 2017 Motor Assembly Replacement, Remove zip ties: 步骤 3 中的图像 1，2 MiTM Pressure Washer CM1400HDEC1 2017 Motor Assembly Replacement, Remove zip ties: 步骤 3 中的图像 2，2

    • Remove the zip ties holding the power cord to the frame assembly.

    • During reassembly, replace these zip ties after you have bolted the motor in place to ensure there is enough slack between the frame and the electrical box.

    编辑

  5. MiTM Pressure Washer CM1400HDEC1 2017 Motor Assembly Replacement, Remove the motor: 步骤 4 中的图像 1，2 MiTM Pressure Washer CM1400HDEC1 2017 Motor Assembly Replacement, Remove the motor: 步骤 4 中的图像 2，2

    • Remove the motor and pump assembly from the frame.

    编辑

  6. MiTM Pressure Washer CM1400HDEC1 2017 Motor Assembly Replacement: 步骤 5 中的图像 1，1

    • If your replacement motor comes with pre-installed rubber isolator feet, remove the bolts in them before installing the new motor to the frame assembly.

    • You can re-install the motor with the new feet or the original ones, but only the original 11 mm hex head bolts from the frame assembly are long enough to safely secure the motor to the frame.

    编辑
结论

To reassemble your device, follow these instructions in reverse order.

作者

与1其他贡献者

Taylor Dixon

于06/26/18注册

67,119 声望

创作了94篇指南

徽章: 40

+ 37更多徽章

0条评论

添加评论

浏览统计数据:

过去 24 小时： 3

过去 7 天： 18

过去 30 天： 54

总计 1,001