跳转到主内容

简介

Reclaim your singular source of internet connectivity by replacing your broken AirPort/Bluetooth board.

  1. Unplug your MacBook Air and power it off before you proceed.
    • Unplug your MacBook Air and power it off before you proceed.

    • Remove ten Phillips screws securing the lower case to the MacBook Air:

    • Six 2.8 mm screws

    • Two 3.8 mm screws

    • Two 5.4 mm screws

  2. Slightly lift the lower case near the vents and push it toward the rear of the computer to free the mounting tabs. Slightly lift the lower case near the vents and push it toward the rear of the computer to free the mounting tabs.
    • Slightly lift the lower case near the vents and push it toward the rear of the computer to free the mounting tabs.

  3. Disconnect the battery connector by pulling it straight out of its socket.
    • Disconnect the battery connector by pulling it straight out of its socket.

  4. Android 维修工具包

    A new screen or battery is one kit away.

    现在开始购物

    Android 维修工具包

    A new screen or battery is one kit away.

    现在开始购物
  5. Remove the following nine screws securing the battery to the Air:
    • Remove the following nine screws securing the battery to the Air:

    • Four 2.9 mm Phillips.

    • Four 3.8 mm Phillips.

    • One 7.2 mm Phillips.

  6. Lift the battery out of the Air.
    • Lift the battery out of the Air.

    • If you're installing a new battery, you should calibrate it after installation:

    • Charge it to 100%, and then keep charging it for at least 2 more hours. Then, unplug and use it normally to drain the battery. When you see the low battery warning, save your work, and keep your laptop on until it goes to sleep due to low battery. Wait at least 5 hours, then charge your laptop uninterrupted to 100%.

    • If you notice any unusual behavior or problems after installing your new battery, you may need to reset your MacBook's SMC.

  7. Remove the two following screws securing the AirPort/Bluetooth board bracket to the upper case: One 4.7 mm Phillips.
    • Remove the two following screws securing the AirPort/Bluetooth board bracket to the upper case:

    • One 4.7 mm Phillips.

    • One 3.9 mm Phillips.

    • Lift the AirPort/Bluetooth bracket out of the upper case.

  8. Using a spudger, pry the AirPort/Bluetooth ribbon cable connector straight up off the AirPort/Bluetooth board.
    • Using a spudger, pry the AirPort/Bluetooth ribbon cable connector straight up off the AirPort/Bluetooth board.

  9. Use a spudger to pry the three antenna cables up off the AirPort/Bluetooth board.
    • Use a spudger to pry the three antenna cables up off the AirPort/Bluetooth board.

  10. Remove the single 3.2 mm Phillips screw from the upper right corner of the AirPort/Bluetooth board. Lift the AirPort/Bluetooth board out of the upper case.
    • Remove the single 3.2 mm Phillips screw from the upper right corner of the AirPort/Bluetooth board.

    • Lift the AirPort/Bluetooth board out of the upper case.

结论

To reassemble your device, follow these instructions in reverse order.

9等其他人完成本指南。

添加评论

浏览统计数据:

过去的24小时: 3

过去的7天: 12

过去的30天: 51

总计 35,599