跳转到主内容

修复你的物品

维修的权力

配件 & 工具

简介

Use this guide to replace the camera in your Huawei P9 smartphone. When reassembling your phone apply new adhesive where it is necessary.

  1. First switch off your phone and remove the SIM card tray. Unscrew the two Pentalobe P2 screws located at the bottom next to the device's USB C port. If the screen is cracked you might want to use some tape to protect your eyes from glass shreds and get a better grip to open the phone.
    • First switch off your phone and remove the SIM card tray.

    • Unscrew the two Pentalobe P2 screws located at the bottom next to the device's USB C port.

    • If the screen is cracked you might want to use some tape to protect your eyes from glass shreds and get a better grip to open the phone.

  2. Avoid to lift only the display instead of the whole phone assembly as doing so may cause damage to the screen. Use an iSclack or a suction handle to separate the phone assembly from the rear panel.
    • Avoid to lift only the display instead of the whole phone assembly as doing so may cause damage to the screen.

    • Use an iSclack or a suction handle to separate the phone assembly from the rear panel.

    • In case you can‘t manage to lift the phone assembly out of the rear panel you can insert the pointed end of a spudger in the headphone jack opening and press the phone assembly upwards until you create a gap between assembly and rear panel. Then use the spudger to lever the phone assembly out of the panel.

    • Don't remove the rear panel completely yet. There is a cable connected to it! It is running from the finger print sensor to the display unit.

  3. 任天堂 Switch 套装

    A quick fix to get back in the game

    Shop Switch Kits

    任天堂 Switch 套装

    A quick fix to get back in the game

    Shop Switch Kits
  4. Disconnect the fingerprint sensor using a spudger. Disconnect the fingerprint sensor using a spudger.
    • Disconnect the fingerprint sensor using a spudger.

  5. Undo the two Phillips #00 screws. Remove the bracket.
    • Undo the two Phillips #00 screws.

    • Remove the bracket.

    • Mind the connector underneath.

  6. Release the connector. Loosen the camera from the motherboard and take it away.
    • Release the connector.

    • Loosen the camera from the motherboard and take it away.

结论

To reassemble your device, follow these instructions in reverse order. When reassembling your phone apply new adhesive where it is necessary.

4等其他人完成本指南。

Dominik Schnabelrauch

于2016年11月23日注册

52,496 信誉积分

创作了250篇指南

团队

iFixit iFixit 的会员

Community

107 名成员

创作了10,279篇指南

添加评论

浏览统计数据:

过去的24小时: 2

过去的7天: 5

过去的30天: 41

总计 2,789