简介

Before attempting to repair this toy you need to consider that the manufacturer has glued a cover over a screw. To remove this will leave a broken part (which you can glue on later) and that tool marks may remain visible (can mostly be smoothed back down with a warmed metal spatula/rod)

  1. Remove 1 screw securing battery cover. Remove batteries.
    • Remove 1 screw securing battery cover. Remove batteries.

    • remove 2 screws from dog belly that were hidden by battery cover.

    添加评论

  2. Using either a screwdriver, craft knife or similar, pry or cut the cover on top of screw beside back left leg. Remove single screw.
    • Using either a screwdriver, craft knife or similar, pry or cut the cover on top of screw beside back left leg. Remove single screw.

    • Use craft knife to ease between joints of rear leg cover and cut through glue. Remove cover.

    • Fuse is hidden beneath leg

    • remove 2 screws from beneath leg.

    添加评论

    • Remove 2 screws-1 each next to front legs.

    • Use a plastic spudger to pry between upper and lower body.

    • Ease the casing up and over jack opening.

    • Remove lower casing, front legs may still be attached to case but will easily pull free. When reattaching the body it is easiest to place legs in lower case and then place upper case on top.

    添加评论

    • desolder battery contacts.

    • remove screws securing motherboard to battery housing.

    • lift motherboard up from housing, you may have to bend fuse (that was soldered to battery contact) slightly to allow movement. Be careful as it is still attached to jack and motor.

    添加评论

    • remove 2 screws accessed through battery housing. (Jack slides from motor housing and is easily resited it is not secured in place)

    添加评论

    • remove 2 screws holding motor to battery compartment that were hidden beneath jack and wiring near battery opening.

    • Lift motor housing up slightly to allow battery compartment to be removed. You may have to "wiggle" neck joint/silver attachment to allow this.

    • The removed battery compartment. You will need to use a sharp blade to cut along joins to fully access battery contacts for a thorough clean.

    添加评论

结论

To reassemble your device, follow these instructions in reverse order.

4等其他人完成本指南。

pollytintop

于2010年06月09日注册

75,290 信誉积分

创作了6篇指南

团队

Master Techs Master Techs 的会员

Community

278 名成员

创作了755篇指南

I struggled to remove the back cover to clean the battery corrosion off. So, I had an amazing idea. Q-tips and vinegar! I dipped a q-tip in vinager and reaches it down to the bottom of the compartment, cleaning it thoroughly. I dryed it with dry q-tips and small paper towel pieces. I placed new batteries inside and it worked again!

Aza'lea Benjamin - 回复

添加评论

浏览统计数据:

过去的24小时: 1

过去的7天: 15

过去的30天: 64

总计 5,285