跳转到主内容

简介

Note: The best time to do this is when the system is new. Older systems may have a visible contrast where the stickers are removed. An example is shown in the cover photo.

On many PCs, the OEM puts branding stickers on, which are prone to wear on laptops. Removing these from a laptop will keep the palmrest clean or clean up an old system with worn out stickers.

Guide notes

  • IMPORTANT: The battery must be removed if it is easily accessible and installed where heat is needed. These can explode if they get hot.
    • Follow the guide specific to your laptop to do this. Instructions are not included in this guide, as all laptops are different.
  • Be careful how much heat you use. Plastic parts can be melted if they get too hot. These will need to be replaced if this happens.
    • To avoid damaging the plastics, only use enough heat to make removal easy.
  • Goof Off WILL DAMAGE MOST PLASTICS. Use Goo Gone, as it is far safer and doesn't damage most surfaces.
    • If you are in uncomfortable using solvents, a piece of tape can also be used.

------------------------------------------------------------------------------------------------------------------------------

Potentially difficult to remove stickers

  • In most cases, Windows XP/all Intel/pre-2011 AMD stickers leave a lot of residue behind as they age. This is largely unavoidable (but easily cleaned).
    • While less common with modern stickers (Vista/7/post-2011 AMD), these can still come off dirty.
  • This procedure can be used to remove most stickers; not just Intel/AMD/nVidia/Windows stickers. These were removed from this laptop as an example.
    • While some stickers can be harder than others (often due to age or the type of glue used), the same procedure will apply.

配件

  1. The procedure to remove the battery varies from laptop to laptop. Before removing the stickers, remove the battery.
    • The procedure to remove the battery varies from laptop to laptop.

    • Before removing the stickers, remove the battery.

  2. PC 笔记本电池

    An easy fix for a big power boost.

    现在开始购物

    PC 笔记本电池

    An easy fix for a big power boost.

    现在开始购物
    • 30-60 seconds of heat will break the glue down.

    • If the sticker is thin, a guitar pick can help.

    • After removing the battery, use a hairdryer to warm up the system. Do this until the glue is soft.

    • Peel off the stickers when the palmrest is hot to the touch.

  3. The bottle my Goo Gone came from broke. I replaced the bottle since it was full. After the sticker(s) have been removed, clean the leftover glue. Use a gentle citrus solvent. Only use enough solvent on the system to remove the residual glue.
    • The bottle my Goo Gone came from broke. I replaced the bottle since it was full.

    • After the sticker(s) have been removed, clean the leftover glue. Use a gentle citrus solvent.

    • Only use enough solvent on the system to remove the residual glue.

    • Wipe the glue off after a few seconds. The hot glue will wipe off easily.

终点

2等其他人完成本指南。

Nick

于2009年11月10日注册

49,739 信誉积分

创作了39篇指南

团队

Master Techs Master Techs 的会员

Community

287 名成员

创作了819篇指南

添加评论

浏览统计数据:

过去的24小时: 3

过去的7天: 21

过去的30天: 121

总计 1,355