跳转到主内容

简介

If your hoverboard will not turn on, follow this guide to replace the power button.

配件

没有特定配件。

  1. Flip the hoverboard so the bottom is facing up. The right side is the side that has the power button. There is also an "R" on the metal plate underneath the battery.
    • Flip the hoverboard so the bottom is facing up.

    • The right side is the side that has the power button. There is also an "R" on the metal plate underneath the battery.

  2. Using a Phillips #1 screwdriver, remove the two 14 mm screws closest to the center of the hoverboard. Using a Phillips #1 screwdriver, remove the four 12 mm screws located in the middle of the panel.
    • Using a Phillips #1 screwdriver, remove the two 14 mm screws closest to the center of the hoverboard.

    • Using a Phillips #1 screwdriver, remove the four 12 mm screws located in the middle of the panel.

    • Using a Phillips #1 screwdriver, remove the two 15 mm screws located closest to the wheel.

  3. Grip the bottom right panel and lift to remove it. Grip the bottom right panel and lift to remove it. Grip the bottom right panel and lift to remove it.
    • Grip the bottom right panel and lift to remove it.

  4. Disconnect the battery by holding the yellow connectors and pulling apart. Disconnect the battery by holding the yellow connectors and pulling apart.
    • Disconnect the battery by holding the yellow connectors and pulling apart.

  5. Unplug the red and black power button connector on the motherboard by squeezing the connector and pulling away from the board. You can also unplug the light connector to free up your work space. You can also unplug the light connector to free up your work space.
    • Unplug the red and black power button connector on the motherboard by squeezing the connector and pulling away from the board.

    • You can also unplug the light connector to free up your work space.

  6. Use an adjustable wrench to remove the 14 mm nut holding the button in the shell. Use an adjustable wrench to remove the 14 mm nut holding the button in the shell.
    • Use an adjustable wrench to remove the 14 mm nut holding the button in the shell.

  7. Pull the power button out of the panel. Replace the power button. Replace the power button.
    • Pull the power button out of the panel.

    • Replace the power button.

结论

To reassemble your device, follow these instructions in reverse order.

Alexander Pham

于2018年10月07日注册

209 信誉积分

撰写一个指南

团队

Cal Poly, Team S15-G4, White Fall 2018 Cal Poly, Team S15-G4, White Fall 2018 的会员

CPSU-WHITE-F18S15G4

4 名成员

创作了8篇指南

添加评论

浏览统计数据:

过去的24小时: 0

过去的7天: 0

过去的30天: 3

总计 54