简介

Removing the logic board from the Garmin Nuvi 200

  1. Peel off the sticker from the bottom of the device to reveal two screws.
    • Peel off the sticker from the bottom of the device to reveal two screws.

    添加评论

  2. Remove two T5 Torx screws.
    • Remove two T5 Torx screws.

    添加评论

    • Insert a plastic opening tool in the gap between the front and rear casing.

    • Carefully work the tool around the gap, separating the two halves of the case.

      • Keep the power switch in place while removing the rear case.

    添加评论

  3. 传播 Fixmas 欢乐
    Get $12 off your purchase of $50 or more with code FIXMAS12
    传播 Fixmas 欢乐
    Get $12 off your purchase of $50 or more with code FIXMAS12
    • Peel away the tape holding the ribbon cable in place.

    • Disconnect the ribbon cable by using a spudger to flip up the retaining flap on its ZIF-style connector. Then gently remove the cable.

    添加评论

    • Pull out the cable between the logic board and the speaker to disconnect them.

    添加评论

    • Remove the three screws from the logic board using the #00 Phillips screwdriver.

    • Lift the board away from the case but do not pull the logic board completely off, as it is still attached to the battery by a cable.

    添加评论

    • Detach the logic board form the battery by pulling out the cable.

    添加评论

结论

To reassemble your device, follow these instructions in reverse order.

另外一个人完成了本指南。

Anjelica

于2010年04月11日注册

504 信誉积分

创作了3篇指南

团队

Cal Poly, Team 25-90, Amido Spring 2010 Cal Poly, Team 25-90, Amido Spring 2010 的会员

CPSU-AMIDO-S10S25G90

4 名成员

创作了9篇指南

添加评论

浏览统计数据:

过去的24小时: 0

过去的7天: 3

过去的30天: 16

总计 9,626