简介

This guide will show you how to repair the Game Boy Color's power LED. The power led glows red when the device is turned on indicating that it is receiving power.

Locate the battery compartment on the back of the Game Boy Color. Push down on the tab and hinge the cover downwards and outwards to remove the battery cover.
  • Locate the battery compartment on the back of the Game Boy Color.

  • Push down on the tab and hinge the cover downwards and outwards to remove the battery cover.

添加评论

Remove the batteries from the battery compartment.
  • Remove the batteries from the battery compartment.

添加评论

Using a Y1 screwdriver, remove the six screws on the back of the device as pictured.  The bottom two screws are located inside of the battery compartment.
  • Using a Y1 screwdriver, remove the six screws on the back of the device as pictured. The bottom two screws are located inside of the battery compartment.

添加评论

Gently lift and separate the back housing from the rest of the device.  Now you've got the back housing out! Gently lift and separate the back housing from the rest of the device.  Now you've got the back housing out!
  • Gently lift and separate the back housing from the rest of the device. Now you've got the back housing out!

添加评论

Mac RAM 套件
加速你的Mac。充分利用它的内存。
Mac RAM 套件
从Mac中清理出更多内存。
Using the Phillips #1 screwdriver, remove the 3 screws shown in the picture. Using the Phillips #1 screwdriver, remove the 3 screws shown in the picture.
  • Using the Phillips #1 screwdriver, remove the 3 screws shown in the picture.

添加评论

Gently lift the motherboard from the front housing.
  • Gently lift the motherboard from the front housing.

添加评论

Unsolder and remove the LED from the circuit board. Click here for a guide on how to solder and unsolder

添加评论

Insert new LED into the circuit board.
  • Insert new LED into the circuit board.

  • Make sure that the LED is in the correct orientation. The longer leg of the LED is the positive end, while the shorter leg is the negative end.

  • The positive lead should go through the hole closest to the edge of the circuit board.

添加评论

Solder the leads of the new LED to the circuit board.
  • Solder the leads of the new LED to the circuit board.

添加评论

Cut the excess ends of the LED legs using the wire cutters.
  • Cut the excess ends of the LED legs using the wire cutters.

添加评论

结论

To reassemble your device, follow these instructions in reverse order.

4等其他人完成本指南。

Alex Wu

于2013年01月11日注册

788 信誉积分

创作了5篇指南

团队

Cal Poly, Team 19-47, Regan Winter 2013 Cal Poly, Team 19-47, Regan Winter 2013 的会员

CPSU-REGAN-W13S19G47

4 名成员

创作了24篇指南

what is the brass color looking thing under the soldering iron in step 7?

Soul Divide - 回复

That's called 'Desoldering Braid', it sucks up solder like a wick

John Smith -

and what kind of LED are you using to replace?

Soul Divide - 回复

添加评论

浏览统计数据:

过去的24小时: 3

过去的7天: 15

过去的30天: 87

总计 7,004