本指南有最近更改,您可查看未经巡查的最新版本。
简介
This guide will show you how to disassemble the back and side panel of the printer.
你所需要的
-
-
Remove the following two Phillips screws:
-
Two 7.85 mm Phillips #1 screws
-
-
-
Pull the back cover off by lifting up on the cover.
"quite a bit of force" is almost an understatement, I found 2 clips along the bottom of that rear piece, one at the far left one around the middle (indicated by an arrow on the underside of the machine) - undoing these required much persistence with a screwdriver
Thank you, Perhaps Fuzz. Thank you.
-
-
To reassemble your device, follow these instructions in reverse order.
To reassemble your device, follow these instructions in reverse order.
6等其他人完成本指南。