Corsair Dark Core RGB PRO SE Mouse Nano-Switches Replacement

简介

If you have been using your Corsair Dark Core RGB Pro SE mouse for a while and noticed that it's becoming unresponsive or the clicks are not working properly, it could be due to worn-out mouse nano-switches. This guide will provide you with step-by-step instructions on how to replace the mouse nano-switches of your Corsair Dark Core RGB Pro SE.

你所需要的

步骤 1 Glide Pads

Corsair Dark Core RGB PRO SE Mouse Nano-Switches Replacement, Glide Pads: 步骤 1 中的图像 1，2

Corsair Dark Core RGB PRO SE Mouse Nano-Switches Replacement, Glide Pads: 步骤 1 中的图像 2，2

Cover the sensor on the bottom of the mouse with your thumb so it doesn't get damaged.
Use the heat gun on the bottom of the mouse to loosen the glue on the pads.
Repeat this step with the other glide pads.

编辑

步骤 2 Mouse Nano-Switches

Corsair Dark Core RGB PRO SE Mouse Nano-Switches Replacement, Mouse Nano-Switches: 步骤 2 中的图像 1，1

Remove the two screws from the bottom of the mouse using a T5 Torx screwdriver.

编辑

步骤 3

Gently pry open the mouse shell using an iFixit opening tool.
Be careful not to force anything or use excessive force, as you may damage the components inside the mouse.

编辑

步骤 4

Use an iFixit opening tool to gently pry up the right and left click buttons on the top cover of the mouse until they pop out of place.
Be careful not to damage the wiring harnesses that connect the buttons to the PCB.

编辑

步骤 5

Use an iFixit opening tool to gently lift the top cover from the mouse body.
Be careful not to damage the wires connecting the cover to the mouse PCB.

编辑

步骤 6

Using a plastic opening tool, gently pry up the side button assemblies until they pop out of place.
Be careful not to damage the wiring harnesses that connect the buttons to the PCB.

编辑

步骤 7

Remove the screws that hold the circuit board in place using a Phillips #0 screwdriver.
Gently lift the PCB and set it aside.

编辑

步骤 8

在这个步骤中使用的工具：

Tweezers

$4.99

购买

With the nano-switches now exposed, use a soldering iron to melt the solder holding the old switches in place.
Use tweezers to carefully remove the old switches and desolder any remaining solder.