Canon Selphy CP910 Buttons Replacement

简介

The Canon Selphy CP910 is used to print pictures from a camera and WiFi connection. If there are any issues with the buttons on the printer, it may be necessary to remove them. For information regarding troubleshooting issues with the Canon Selphy CP910, go to Canon Selphy CP910 Troubleshooting.

Contact the manufacturer for inquiries about receiving parts of the Canon Selphy CP910.

你所需要的

步骤 1 Disassembling Canon Selphy CP910 Body

Canon Selphy CP910 Buttons Replacement, Disassembling Canon Selphy CP910 Body: 步骤 1 中的图像 1，2

Canon Selphy CP910 Buttons Replacement, Disassembling Canon Selphy CP910 Body: 步骤 1 中的图像 2，2

Turn the printer over.
Use the PH1 screw bit to remove the three 8 mm screws in the middle of the back plate.
Keep track of these screws because you will need them to reassemble the printer.

编辑

步骤 2

Canon Selphy CP910 Buttons Replacement: 步骤 2 中的图像 3，3

Loosen up the four 10 mm corner screws.
A screwdriver with a long shaft approximately 7mm in diameter will make it easier to reach these screws.

编辑

步骤 3

Canon Selphy CP910 Buttons Replacement: 步骤 3 中的图像 3，3

Turn the device around and remove the "open" lid.
This lid needs to be removed in order to take the printer apart.
Gently bend the lid and remove it from its hinges.

编辑

步骤 4

Canon Selphy CP910 Buttons Replacement: 步骤 4 中的图像 3，3

Turn the device back over and lift the top panel up.
Disconnect the ribbon cables leading to the LCD screen.
Pull the top panel off.

编辑

步骤 5 Buttons

Canon Selphy CP910 Buttons Replacement, Buttons: 步骤 5 中的图像 1，2

Canon Selphy CP910 Buttons Replacement, Buttons: 步骤 5 中的图像 2，2

Turn the top panel over so the inside faces toward you.

编辑

步骤 6

Canon Selphy CP910 Buttons Replacement: 步骤 6 中的图像 3，3

Use the PH0 screw bit to remove the five 10 mm screws located above the circuit board.

编辑

步骤 7

Carefully remove the frame attached to the screen.

编辑

步骤 8

Canon Selphy CP910 Buttons Replacement: 步骤 8 中的图像 3，3

Take out the circuit board.
Once you take out the circuit board, you should be left with just the case.

编辑

步骤 9

There is a clear plastic “L” shaped piece that acts as the power light for the printer. The piece is not attached to the printer so take care not to lose it.
Remove the button framework and replace it with new one.

编辑