简介

This guide shows the user how to take out the logic board, and therefore have the opportunity to replace a defective board.

配件

无需配件。

Remove the battery and SD Card from their slots.  Leaving these in could cause the battery to ground and ruin the electronics.
  • Remove the battery and SD Card from their slots. Leaving these in could cause the battery to ground and ruin the electronics.

  • Unscrew the six screws on the casing. Two are on the bottom as pictured; two more are on each side of the camera.

添加评论

Pull the lanyard mount off of the camera using a spudger or your fingers.
  • Pull the lanyard mount off of the camera using a spudger or your fingers.

添加评论

  • Find the line that separates the casing into its two halves. Hold each half seperately, and gently pull apart.

  • Note that there is a small metal clip holding the two halves together. It might help to press down on the back half (indicated) while pulling upward slightly on the front half.

添加评论

  • Take hold of the inside of the camera, and gently pull away from the back casing.

添加评论

  • Remove the square, clear, rubber protector from the front of the logic board. This is not necessary to remove, but can easily fall off and get lost during later steps.

添加评论

  • When you reassemble the camera, make sure the switch on the casing (pictured left) matches the position of the switch on the camera internals.

  • The black viewfinder padding (pictured right) can easily fall off the casing. Make sure you don't lose it when moving around parts.

添加评论

  • Remove the LCD cable by gently prying the hinge open with a spudger or your finger. The cable should easily slide out.

添加评论

  • Lift up the metallic-colored clip with the spudger to remove the shutter panel.

添加评论

  • Remove the shutter panel with the spudger, now that the clip is released.

添加评论

  • Use the spudger or your finger to release the orange ribbon from the logic board.

添加评论

  • Pull the ribbon out of the socket using the spudger or your finger.

  • Disconnect the two other ribbons from the logic board in the same fashion.

添加评论

  • Lift up the large green flap by using the spudger to pry up top right yellow edge.

添加评论

  • Pull the flap back with the spudger so that the logic board is exposed.

添加评论

  • Use the screwdriver to remove the three screws on the logic board. Take note that the bottom right screw is shorter than the other two.

添加评论

  • Use the spudger to carefully remove the logic board from behind.

添加评论

  • Remove the detached logic board from the camera.

添加评论

结论

To reassemble your device, follow these instructions in reverse order.

Chris Wren

于2010年04月11日注册

51 信誉积分

撰写一个指南

团队

Cal Poly, Team 25-85, Amido Spring 2010 Cal Poly, Team 25-85, Amido Spring 2010 的会员

CPSU-AMIDO-S10S25G85

4 名成员

创作了5篇指南

添加评论

浏览统计数据:

过去的24小时: 0

过去的7天: 0

过去的30天: 0

总计 1,918