简介

USB Port can be damaged from force exertion on the pins which can prevent it to connect to an external device. This guide will show the steps to replace the USB port in the device.

Remove the four 2mm Phillips #00 screws on both sides of the camera.
  • Remove the four 2mm Phillips #00 screws on both sides of the camera.

添加评论

Remove the single 4mm Phillips #00 screw from the bottom.
  • Remove the single 4mm Phillips #00 screw from the bottom.

添加评论

  • Remove the front face panel off of the camera.

添加评论

  • Remove the rear panel of the camera.

  • The user interface panel, side and bottom panel of the camera may fall down by itself while you are taking the rear panel of the camera.

添加评论

  • Remove the 3mm Phillips #000 screw from the top of the camera.

添加评论

  • Pry the golden ribbon cable from the motherboard with a plastic opening tool.

  • A screw will be visible underneath the golden ribbon after prying it.

添加评论

  • Remove the 3mm Phillips #000 screw from the motherboard.

添加评论

  • Use a plastic opening tool to flip up the retaining flap on the ribbon cable ZIF socket.

添加评论

  • Unplug the small chip from the face of the camera using a pair of tweezers.

添加评论

  • Remove the 3mm Phillips #000 screw from the rear face of the camera.

添加评论

  • Remove the top panel from the camera.

添加评论

  • Pry the golden ribbon cable attached to the USB port using a plastic opening tool.

添加评论

  • Remove the 3mm Phillips #000 screw located at the top right of the USB port.

添加评论

  • Remove the USB port.

添加评论

结论

To reassemble your device, follow these instructions in reverse order.

Faris Rezwan

于2018年05月21日注册

433 信誉积分

创作了2篇指南

团队

IUPUI, Team S1-G2, Harley Spring 2018 IUPUI, Team S1-G2, Harley Spring 2018 的会员

IUPUI-HARLEY-S18S1G2

7 名成员

创作了4篇指南

添加评论

浏览统计数据:

过去的24小时: 0

过去的7天: 0

过去的30天: 0

总计 110