简介

Removing the grip is necessary to reach the battery door. This process is safe and easy.

配件

无需配件。

Remove the two 4.8 mm black screws above the lens on the front of the camera.
  • Remove the two 4.8 mm black screws above the lens on the front of the camera.

添加评论

Remove the 4.3 mm black screw under the lens ring, and the 4.8 mm black screw under the camera.
  • Remove the 4.3 mm black screw under the lens ring, and the 4.8 mm black screw under the camera.

添加评论

  • Remove the 4.8 mm black screw on the left side of the camera.

添加评论

  • Remove the front panel by lifting it away from the camera's body.

添加评论

  • Slide the outer eyepiece upward to remove it.

添加评论

  • Remove the two 4.75 mm black screws located on the top of the camera.

添加评论

  • Remove the four 4.3 mm black screws near the bottom corners of the eyepiece at the back of the camera.

添加评论

  • Slowly separate the top panel from the camera by pushing it upward.

  • Separating the top panel too far or quickly can damage the ribbon cable and connecting wires that are still attached to the top panel of the camera.

添加评论

  • Remove two 6.5 mm black screws from the panel.

添加评论

  • Remove the plastic remote control socket cap by pulling it straight out.

添加评论

  • Slide panel toward bottom of camera to remove.

添加评论

  • Remove the two 5.5 mm screws from front of camera.

添加评论

  • Remove grip panel.

添加评论

结论

To reassemble your device, follow these instructions in reverse order.

Jackie

于2011年04月17日注册

218 信誉积分

创作了3篇指南

团队

Cal Poly, Team 8-8, Regan Spring 2011 Cal Poly, Team 8-8, Regan Spring 2011 的会员

CPSU-REGAN-S11S8G8

5 名成员

创作了11篇指南

添加评论

浏览统计数据:

过去的24小时: 0

过去的7天: 3

过去的30天: 18

总计 2,855