修复你的物品

维修的权力

商店

Audio Technica ATH-AD500 Left Headphone Cable Replacement

撰写者： Melanie Reis (和另外7个贡献者)
  • 评论： 4
  • 收藏 5
  • 完成 2

难度

困难

步骤

6

所需时间

20 - 30 分钟

节

2

标志

0

简介

This repair guide will help you with the following:

  • Install the left headphone cable
  • Fix sound coming from the left headphone

  1. Remove the ear pads by peeling them away from the grill.

    • Remove the ear pads by peeling them away from the grill.

    翻译

  2. Remove all four 1cm screws on the inside of the headphone using a #1 Phillips head.

    • Remove all four 1cm screws on the inside of the headphone using a #1 Phillips head.

    翻译

  4. Remove the speaker from the grill by pulling it out.

    • Remove the speaker from the grill by pulling it out.

    • Remove the speaker carefully so you do not rip the wires out.

    翻译

  5. Desolder the red, yellow, and blue wires using a soldering iron and desoldering wick. If you need assistance, reference 如何焊接和拆焊. The areas where you desolder will be hot so wait until the desoldered joints are cool before handling the wires again. The areas where you desolder will be hot so wait until the desoldered joints are cool before handling the wires again.

    • Desolder the red, yellow, and blue wires using a soldering iron and desoldering wick. If you need assistance, reference 如何焊接和拆焊.

    • The areas where you desolder will be hot so wait until the desoldered joints are cool before handling the wires again.

    翻译

  6. Untie the knot in the thick main cable. Remove the main cable from the headphones by pulling it out.

    • Untie the knot in the thick main cable.

    • Remove the main cable from the headphones by pulling it out.

    • Thread the replacement cable into the hole on the bottom of the headphones. Pull the cable all the way through.

    翻译

  7. Re-solder the new red, yellow, and blue wires using a soldering iron. If you need assistance, reference 如何焊接和拆焊. The areas where you solder will be hot so wait until the solder joints are cool before handling the wires again. The areas where you solder will be hot so wait until the solder joints are cool before handling the wires again.

    • Re-solder the new red, yellow, and blue wires using a soldering iron. If you need assistance, reference 如何焊接和拆焊.

    • The areas where you solder will be hot so wait until the solder joints are cool before handling the wires again.

    翻译
结论

To reassemble your device, follow these instructions in reverse order.

2等其他人完成本指南。

作者

与7其他贡献者

Melanie Reis

于2013年01月11日注册

146 信誉积分

创作了5篇指南

徽章: 10

+ 7更多徽章

团队

Cal Poly, Team 17-19, Forte Winter 2013 Cal Poly, Team 17-19, Forte Winter 2013 的会员

CPSU-FORTE-W13S17G19

6 名成员

创作了6篇指南

一条评论

添加一条评论

Thank you so much! your guide helped me repair my AD900x!

Anwar X - 回复

添加评论

浏览统计数据:

过去的24小时： 1

过去的7天： 11

过去的30天： 53

总计 7,034