声誉积分: 8.6千
79
20
76
I was wondering what screwdriver is required to undo the Game and Watch screws. This question is not for the new Game and watches with the tri-wing screws. This is for the ones from the 80's era.
声誉积分: 34.7千
10
22
44
could you give more info, is it a certain shape etc. like philips could be ph00 gameboy could be gamebit
这个答案有帮助吗？
It looks to be a flathead but idk what size.
i looked at an image and it looks to say 4.3 mm
@tay0_0 an ifixit kit will have most of the bits you need but there are various screwdriver sets on the market, depends on your budget etc
Thank you so much!
过去 24 小时： 0
过去 7 天： 1
过去 30 天： 6
总计 420
1条评论
(Sorry for thread revival).
It's some kind of proprietary variation of a flat head screw with a registration pin in the centre. A standard 3mm flat head will work, but it'll just be a little more precarious than normal because of the gap in the middle. I've only been searching for a day, but I don't know if these are available today. If anything, they might be found in Akihabara in Tokyo or Den-den town in Osaka,
由 Miles Goodhew 完成的