Repair guides and troubleshooting for the Wizard RT550, a rotary tool made by Black & Decker.
Vince DeLuca @vjdeluca
声誉积分: 1
发帖于: 2019年8月2日
After tightening an accessory into place with the collett nut, it doesn’t grip enough, so tool such a saw just stops when pressed against object.
这是一个好问题吗?
tcagle53 @professorc
声誉积分: 8.2千
Professor C's E-repair and Upgrade Service
24
12
8
发帖于: 2019年8月3日
Measure the shaft on the tool in question. It is probably 3/32” and you probably have a 1/8” collet installed in the collet nut. If you have lost that part or did not get it with the tool they are readily available on line.
https://www.ereplacementparts.com/collet...
这个答案有帮助吗?
过去 24 小时: 0
过去 7 天: 5
过去 30 天: 10
总计 339