修复你的物品 社区 商店

这款4.7英寸iPhone于2014年9月19日发布，是iPhone 6 Plus的缩小版。

4994 个问题 查看全部

更多选项

Phone crashed while testing new screen (no screws installed) iTunes ok

I was replacing a screen assembly on iphone 6. before putting the screws back in I turned the device on and tested it. it was working fine. The digitizer shifted a tiny bit (maybe it pulled a connector off?) but the phone went off entirely. I have not been able to get it back on since. I did try a second brand new replacement screen assembly (known good) and it does the same thing.

I can power on the phone and iTunes DOES see and communicate with it.

I installed the screen again (no home button or any connectors except the screen and digitizer) - powered on, used a flashlight and could NOT see anything on the screen in the dark.

All pins on connectors look good. I dont thinks the backlight filter since I cant see anything with a flashlight.

Any ideas or suggestions. Thanks

回答此问题 我也有这个问题

这是一个好问题吗？

是 否
得分 0
1条评论

I should mention, I did not put any screws in so it did not short anything out that way.

由完成的

添加一条评论

1个答案

筛选条件:
最有帮助的 最新 最老的
最有帮助的答案

更多选项

First thing would be to take a close look at the connectors and surrounding areas for any physical damage. If you cannot see anything at all even with a clean screen and a flashlight, you may be looking at a display IC. If just the backlight goes out you can still see a faint image, but if just the display driver (u1501) or display boost (u5302_RF) goes out you can usually still see a backlight on with the screen outside of the frame. Hope this helps, but always start with the easy stuff, like looking over the board for physical marks.

这个答案有帮助吗？

是 否
得分 1
添加一条评论

添加你的答案

Kyle B 将永远感激不已
浏览统计数据:

过去 24 小时： 0

过去 7 天： 4

过去 30 天： 8

总计 50