Had a iPad mini 3 come back for a loose home button re-adjusted and adhered the button back. Went to test the device attempts to boot x2 then red screens
What I have tried
- unplugging anything and everything that's not soldered down minus the LCD
- cameras front and rear
- power button
- digi
- home button
- aux
- antennas
- coaxel cables
What I have not tried
- restoring
Anything would be helpful thank you for your time ahead of time
声誉积分: 159.7千
11
191
368
Have you checked charger port if it's loose? Sometimes you may need to tighten the screws up for the charger port.
Red screen can also mean the tristar (U2 charging) chip being bad or NAND chip failure.
Might need to do a restore but that will wipe data so if data is needed leave restore for last resort.
这个答案有帮助吗？
过去 24 小时： 0
过去 7 天： 0
过去 30 天： 1
总计 61
1条评论
Update1:
- tried new battery x2
- took out sim card
- tested for boot without LCD
由 Mitch Kelly 完成的