screen replaced a phone and the backlight is very dim

Question

iPhone 6s

苹果官方于2015年9月25日正式发售iPhone6S A1688/A1633机型。此机型的修理方式与先前几代差不多, 需要螺丝起子及撬棍工具。同时也适用GSM or CDMA/16, 64 or 123 GB/ 银色, 金色, 深空灰色, 玫瑰金色等机型。

2693 个问题查看全部

Tatorumble Gaming @tatorumble81250

声誉积分: 11

发帖于: 2018年6月6日

更多选项

screen replaced a phone and the backlight is very dim

Hi, so I made a scrrenreplacent and in the beginning the backlight wouldn't work at all so I reinstalled the older one and it barely lights up, I looked through everything and this part right here could be the issue. (On the left)

This Happened at the beginning probably while I was removing the ribon cables and I let my buddy try it but either he put too much force or the tool slipped while he was pulling it off. Anyways it isn't that then I don't know what other part it could be because I've already done 3 scrrenreplacents with success and everything else is in order

已回答！ 显示答案我也有这个问题

这是一个好问题吗？

是否

得分 0

添加一条评论

2个答案

已选择的解决方案

A One Mobiles @aonemob

声誉积分: 1.2千

4

1

5

发帖于: 2018年6月6日

更多选项

As @refectio said, failure to disconnect the battery during a screen replacement can cause the backlight anode filter FL4211 to blow (and other upstream components such as diodes, coils, and driver ic), and yours most certainly is.

You can tell from the photo, where it is evident heat has escaped from under the conformal coating, see the attached edit of your photo. Classic anode filter failure. They normally weld to the pads.

The other connector is for the front camera. This board is going to need motherboard repair/microsoldering.

Be very sure in future to disconnect the battery prior to repair. Not only does this line get the full battery current even with the device off (about 7A peak before the PTC trips, at up to 4.35V (That's 30 Watts!), but with the device on its about 22V.

这个答案有帮助吗？

是否

得分 4

添加一条评论

Minho @refectio 声誉积分: 221.5千 15 290 807 · Answer 1 · 2018-06-06T05:09:59-07:00

Minho @refectio

声誉积分: 221.5千

15

290

807

发帖于: 2018年6月6日

更多选项

The damaged connector on the left is the Front Camera connector so I doubt it has anything to do with your backlight issue.

Did you disconnect the battery prior to removing the screen assembly? That is the leading cause of backlight issues on the iPhone 6S. Leaving the battery connected means the power is still on the connector and any misalignment during disconnection but especially reconnection will cause the backlight filter to blow. Sometimes it is only partially damaged and other times the damage can be so severe that it also affects the upstream components.

这个答案有帮助吗？

是否

得分 2

添加一条评论

iPhone 6s

screen replaced a phone and the backlight is very dim

2个答案

添加你的答案