声誉积分: 109
2
2
I just had the lower right button cover crack and fall off. Does anybody know of any ways to get a replacement rubber panel?
Has anybody taken the watch apart to see if it's even possible to do this sort of replacement?
声誉积分: 25
1
I know the original question is an old one, but since a lot of pebble 2s eventually have this problem, here’s a link to my 3D buttons and cases on Shapeways.
这个答案有帮助吗？
Update, if Shapeways’ postage is too high, you can buy buttons from the website now too.
声誉积分: 13
1
I had the same problem und found this site, with printable 3D Models:
这个答案有帮助吗？
声誉积分: 13
1
https://www.shapeways.com/product/UAMY5G...
Requires OG Pebble parts, but this may be a good fix.
I found this just now, I have two P2HRs that both need new buttons, but I think this may be an easier fix. https://tinyurl.com/k8a5h6na UPDATE (08/05/2021) I bought the version with the battery and glue. It’s a fairly easy transfer. Requires a Soldering Iron and some steady hands, but the fix was worth it! Don’t forget to transfer the microphone seal from your old case to the new one, and use A LOT of glue to get the back sealed back up!
这个答案有帮助吗？
声誉积分: 13
1
Bonjour, j’ai trouvé plusieurs sites qui vendent des boutons.
https://www.shapeways.com/product/ANHBW4...
https://www.shapeways.com/product/4Q27VC...
这个答案有帮助吗？
I have resolved with this:
这个答案有帮助吗？
过去 24 小时： 0
过去 7 天： 6
过去 30 天： 15
总计 6,670
2条评论
this should help you somehow https://www.thingiverse.com/thing:259955...
由 Sebastián Cea 完成的
Thanks, Those shapeways links were useful. It took a bit of hand fitting, but those button panels work and now my favorite watch is running again after being idle for far too long.
由 Frank Scheers 完成的