Help on iPhone 6 plus long screw damage

Question

iPhone 6 Plus

2014年9月19日发布的iphone 6 Plus有着比iphone 6大的5.5英寸屏幕。

1525 个问题查看全部

Tom @iphonerepairtom

声誉积分: 511

5

8

发帖于: 2017年11月19日

更多选项

Help on iPhone 6 plus long screw damage

Hello,

I recently ordered an iPhone 6 plus that I wanted to learn a bit of board repair on and sell it on as I usually do however I was hoping that this would only be a backlight filter replacement. I replaced the filters that needed replacing and the phone still has completely no backlight but you see the image when you put a torch to it. I have noticed there is long screw damage in the holes and I have got a diagram where the traces are.

Can anyone lead me through this repair as I'm unsure if I'm doing this correctly and I have also ordered some 0.1mm jumper wire that I think will be good for the traces. I have some pictures of the bottom right hole that I have tried to pick the layer off of but I don't see what is wrong with it. Can anyone please help me with this, I would be very grateful

已回答！ 显示答案我也有这个问题

这是一个好问题吗？

是否

得分 1

添加一条评论

1个答案

已选择的解决方案

The Microsoldering Shop @teetopp

声誉积分: 14.9千

The Microsoldering Shop

8

29

40

发帖于: 2017年11月19日

更多选项

Other than the Filters, Have you checked shorts on Caps? and/or replaced the 2 Diodes, Coils and Driver IC's? Check D1501, D1589, L1503, L1589, U1502, U1580. If so, and they are good...and you still believe it is long screw damage, use a multimeter in continuity mode (With beep) to check the traces for breaks by probing one end of the trace to the other in exposed areas.

这个答案有帮助吗？

是否

得分 2

3条评论:

I have checked the caps with continuity mode and there is no beep. I have had a look at the traces and there are 3 that are broken. I will highlight the broken traces on the picture of the traces

由 Tom 完成的 2017年11月19日

I would just add a dab of flux, tin the traces and the jumper wire and add 3 jumpers. test it and if working, add a bit of solder mask over the opened area. It is really hard to see the traces in the pictures, but if you have verified they are broken, then Yes, definitely add the jumpers

由 The Microsoldering Shop 完成的 2017年11月19日

Thank you very much, I will keep you updated when I get around to doing that

由 Tom 完成的 2017年11月19日

添加一条评论

I have checked the caps with continuity mode and there is no beep. I have had a look at the traces and there are 3 that are broken. I will highlight the broken traces on the picture of the traces — Tom
I would just add a dab of flux, tin the traces and the jumper wire and add 3 jumpers. test it and if working, add a bit of solder mask over the opened area. It is really hard to see the traces in the pictures, but if you have verified they are broken, then Yes, definitely add the jumpers — The Microsoldering Shop
Thank you very much, I will keep you updated when I get around to doing that — Tom

iPhone 6 Plus

Help on iPhone 6 plus long screw damage

1个答案

添加你的答案