声誉积分: 182
6
3
So I've been using this device for about 3 hours and within that time I needed to charge the battery. When i did that I used it again right after and while I was using it, the device seemed very hot, the battery specifically. What's wrong with my device?
声誉积分: 300
8
1
1
1. You used the device for a long period of time and the battery really got hot, just turn it off and use it again after 20-30 min.
2. Your fan that cools the device might be broken. The fan is what cools the device and stops it from overheating. If broken just remove the fan and add a new one in.
这个答案有帮助吗？
声誉积分: 13
1
I live in an Apartment- I found out on mine, It was my problem… I was runing it at to low of Speed. To keep the sound down….. End of my motor.
这个答案有帮助吗？
声誉积分: 1
1
They use a TO-220 MOSFET inside with a terribly small heatsink and a small glueless mating surface between the MOSFET and the heatsink with a loose rivet. The MOSFET can get too hot and blow (small puff of smoke, sparks…etc.) I just ran into this myself. I’m going to have to desolder the MOSFET(s, there is a second one beside the TO-220) and put them on a better heatsink, properly mated as well. …Conveniently a month after the warranty expires.
*Edit* For anyone needing to replace the electronic assembly inside, the part number is 2610005464.
这个答案有帮助吗？
过去 24 小时： 2
过去 7 天： 19
过去 30 天： 64
总计 7,312
1条评论
My flex shaft is getting hot, not the actual Dremel. The flex spring is very hot after about 10 minutes of operation.
由 tim.bankes 完成的