声誉积分: 23
1
okay so after sucessfully removing the optical drive and installing an SSD, with the help of your guide, (Thank you!) everything seams to be running smoothly except that my bluetooth is no longer functioning. I have gone back inside to disconnect and reconnect twice now, and I do not see any physical damage, however it is still not cooperating.
Has anyone else had this problem? Any advice would be very much appreciated!
声誉积分: 480千
35
329
971
I would start by replacing the AirPort/Bluetooth cable 922-9296 as you may have damaged it in the process of taking it off.
Let us know how it goes.
这个答案有帮助吗？
The airport is still working completely fine though, if the cable was damaged wouldn't both the bluetooth and wifi be out of commission?
Not necessarily. Its the only thing you pulled off to get to the optical drive bay. Did you slip and nick something with your screwdriver on the AirPort card?
声誉积分: 7.6千
13
22
11
There is a piece of black tape that goes over the pins of the wifi/bluetooth/webcam connector. Then, sometimes, there is this little mesh blob thingie that goes on top of the connector/cable.
If the black tape is no longer there, but you put the mesh blob thingie back, it will short pins of the connector. So toss that little mesh thingie in the trash and you will probably have a working setup back.
这个答案有帮助吗？
"little mesh thingie" Louis are you talking about the EMI shielding pad which is conductive? Yes! I agree, you do need to make sure it's not shorting out the board.
声誉积分: 1
1
Hi there,
I have the same problem after installing a SSD. The old HDD replaced my optical drive. I replaced the Airport / Bluetooth Card (to the ...CAX one - to use hopefully handoff) without success. Next step was to replace the flex cable... Still the same Problem. WiFi works without Problems, only Bluetooth is not available.
PRAM, SMC reset didn't help either.
Has anybody an idea?
这个答案有帮助吗？
Does Bluetooth services work at all? If you are having problems setting up Handoff you should review this: Continuity Activation Tool
Are you sure you have the antennas correctly connected? It you are switching the board out the connections are laid out differently between them.
声誉积分: 1
1
Thanks for your reply!
@Dan, Bluetooth is not working at all. I checked the wiring and connected them as described in Mid-2010 MBP upgrade success (MacBookPro6,2)
@Louis Rossmann
I'm not quite sure what you mean with "little mesh blob thingie". Can you see it on the picture?
这个答案有帮助吗？
Did you try a different board? Maybe this one is bad.
过去 24 小时： 0
过去 7 天： 1
过去 30 天： 3
总计 161
