声誉积分: 49
4
2
So when I turn on my Receiver from Standby mode it briefly powers on then makes a signal noise error like you are watching static television then the Receiver turns off and a Red Ring flashes around the Power button. I have tried opening the tv hutch door where the Receiver is at to give it more ventilation because I think that could be a possible culprit. Does anyone know anything specific to this brand or model?
Denon AVR391
声誉积分: 1.6千
12
8
3
Sounds like the unit is going into protect mode. There are a few causes for this. First unhook all the speaker connections. If it stops doing it then, there must have been a short in your speaker cables or speakers. If it continues to go into protect mode you either have a blown power amp or blown power supply(maybe a bad digital boards, but thats highly unlikely). That will have to be serviced by a professional. If the unit was not receiving proper ventilation to begin with chances are it overheated and it caused the current failure. Sorry to hear about your issues, I hope you fix them.
这个答案有帮助吗？
I have two radios they both were in storage for 5 years now both don't work power on for 2-3 seconds then turns off.
how can i fix it my self
My zenon plays for a minute then shuts down with a red light around the on off switch
过去 24 小时： 2
过去 7 天： 6
过去 30 天： 38
总计 23,652
4条评论
When I turn on my receiver it lights up then goes out
由 Cornilya Conner 完成的
Can it b a fuse
由 Cornilya Conner 完成的
It can be a speaker wire connection, pull one wire at a time while switching the unit on and off.
由 bigbyrdak47 完成的
No speakers hooked to mine and it still do it
由 Terrence 完成的