配件 & 工具
== iD95 Will not Turn On == ''After repeated attempts, my device is unable to turn on.'' === Device is Off === On the top panel of the iD95, there is an iHome symbol. This is the Alarm Reset / Power / App Button. This button turns the device "On" and "Off." Press the button to see if the front screen turns on. If it has not turned on, refer to the following section. === AC Adapter is Improperly Attached === Sometimes the iD95 power supply is separated or disconnected from the device. To check this problem, make sure the AC adapter plugs into both the wall and the back of your iD95. Attempt to turn on your iD95. If problem persists, keep reading. === Wall Socket is Broken === In some cases, the device may be failing due to a bad wall socket. To test this issue, use the wall socket to power a device that correctly works. If the wall socket does not work, find a different power source to power your device. Otherwise, if the wall socket does work, you may need to buy a new power cable and replace the power cord port on your iD95. == Sound Quality is Low/Poor == ''The sound quality for my iD95 is weak and distorted.'' === Volume is Too Low === Use the volume dial on the top left of the iD95 to turn up the volume. Clockwise turning will turn up the volume while counter-clockwise turning will turn down the volume. === Sound is Distorted === Sound distortion is easily noticed with high-power speakers when using MP3 files of poor quality. To fix this problem, try and get your music from a reliable MP3 provider like Spotify or iTunes. == iPad/iPod/iPhone is not Charging == ''The iD95 is on but it isn't charging my device.'' === iPad/iPod/iPhone is Docked Improperly === This problem can be caused by a bad device connection. Remove your iPad, iPod, or iPhone from the dock and remove any objects that obstruct a clean connection between the device and the dock. Next, place it back on the dock. '''Note:''' The iD95 does not charge iPod Classic (1G and 2G) === iPad/iPod/iPhone is Locked Up/Frozen === Apple products, like many electrical devices, are susceptible to freezing up. Verify that your device is working properly. If the device is frozen, try restarting the device by turning it "Off" and "On." Refer to the iPad/iPod/iPhone manual for more information. === iPad/iPod/iPhone Adapter is Broken === If your adapter is broken, refer to [guide|14592] guide to replace it. == Alarm Does Not Go Off == ''I set my alarm, but it still doesn't work.'' === Alarm is not Properly Set === Incorrect alarm settings can cause this problem. In order to verify your alarm settings, follow these steps and use the + and - buttons to adjust the settings. First, press and hold the '''Alarm 1''' or '''Alarm 2''' button until a time flashes. Set it to the appropriate alarm time. Next, press the alarm button previously used to change the day settings for the alarm. Press the alarm button again to set the alarm audio source. (Note: If you set it to iPod/iPad/iPhone, make sure to connect an iPod/iPad/iPhone to the iD95.) Next, press the alarm button to set the volume. Finally, press the alarm button to exit and save the alarm settings. === Alarm Number (1 and 2) is Switched === It is very easy to turn on the wrong alarm. If you are setting your alarm, take note of the alarm (1 or 2) that you set and turn on the alarm (1 or 2) that corresponds to the alarm that you previously set. === Backup Battery is Weak === A bad battery could result in this problem. Test the battery by conducting an alarm test. Set up an alarm three minutes from the current time and unplug the device form the wall socket. Next, wait for the alarm to go off. If the alarm did not work, then battery could be too weak. Replace it with a new '''CR2450''' battery. Refer to the [guide|14591] to do this. === Backup Battery is Improperly Installed === Improper battery installation will cause the alarm battery to fail. Make sure the battery was installed correctly by opening the battery housing compartment. Use the [guide|14591] to check to see if the positive (+) side of the battery is facing outwards. == Alarm is Going Off at the Wrong Time == ''After setting my alarm, the alarm went off at the wrong time.'' === AM/PM Settings are Wrong === A subtle error occurs when users miss the AM/PM settings for the iD95 alarm feature. If this is the problem, we have good news: the solution is simple!!! When setting the alarm, make sure to use the '''AM/PM''' setting for the appropriate time. Use AM for the morning (after midnight till noon) and PM for the evening (from noon till midnight). Make sure that both the clock and the alarm are set to the proper AM/PM setting. === Alarm Schedule Setting is Inaccurate === If your alarm goes off on the wrong day, your alarm settings may have been altered. When setting your alarm, use '''7 days''' for an every-day alarm, '''Weekends''' for a Saturday-Sunday alarm, and '''Weekdays''' for a Monday-Friday alarm. === Calendar Dates are Incorrect === If your alarm still goes off on the wrong day, your calendar displayed on the screen may be incorrect. (Note: use the + and - buttons to adjust the following settings) To reset the calendar, press and hold the Clock Button. Cycle through the settings until "Autosync On" appears and press the Clock Button. If this doesn't correct your calendar date, proceed to the next step. Press and hold the Clock Button; toggle through the settings until "Autosync Off" appears. Next, press and release the Clock Button and adjust the '''time'''. Adjust the '''year''' by pressing and releasing the Clock Button again. Now, press and release the Clock Button to adjust the '''month''' and '''date'''. Finally, press and release the Clock Button. Two beeps should confirm that your changes have been saved.