The stereo won't turn on
Everything seems to be alright, but it still won't turn on.
Check the power cable
It goes without saying that before you do anything, you should make sure the device is plugged in before you use it. If there is still a problem, inspect the power cord for any visible weaknesses. This may require you to open the back of the device to see if the power cord connections are intact. Click here for a guide on how to replace the power cable.
I can't hear anything coming from my device
There is a distinct lack of noise from the speakers.
Line-in Switch
Make sure that the volume knob is turned up. After that, listen closely to the speakers. If there is no sound coming through, check the line-in switch. If no device is currently connected the switch should be in the "off" position.
Speaker Problems
There could be problems in the speakers themselves and they might need to be rewired or replaced completely.
Poor sound quality when playing records
Something appears to be making a horrible sound.
Warped Records
Indications of having a warped record:
- record players needle skipping or jumping
- minor warps can affect sound quality
If you think your record is warped the following link has some instructions on how to fix warping. Attempting to fix your warped record can end up causing further damage, so proceed with caution.
http://howto.wired.com/wiki/Fix_a_Warped...
Scratched Records
A simple visual look over the record will be able to tell you if your record is scratched. There are some ways that a fix is possible, be warned that the problem may become worse after attempting.
http://www.wikihow.com/Fix-a-Scratch-on-...
Dust or debris
A clean record is necessary to good sound quality. If you let dust or debris to accumulate over a long period of time, your record could be damaged as well as your device. There are different ways that cleaning can be done, it is recommended you do your own research to understand what you need.
https://vinyliq.com/how-to-clean-vinyl-r...
Old or damaged Needle
If you suspect that the needle needs to be replaced, a manual repair is necessary.
Check out the repair guide for a how-to.
Failed Vibration Dampeners
The silicone green circular things you can see when you take off the turntable are there to dampen the vibration that can occur as the turntable spins. You may need to tighten or replace these silicone dampeners. Click here for a guide on how to access the silicone vibration dampeners.
The top lid won't stay open
The top lid will not lock in place even when it is fully open.
Bad hinge
The top is supported by a metal hinge joint that may be functioning improperly. Click herefor a guide on replacing the top hinge.
I can't play CD's
I put the CD in, but for some reason I can't play it.
Check CD orientation
Make sure the CD is inserted correctly (label side up).
Check the function setting
Check to see what the function on the device is set for. If it does happen to be set on the CD position. Eject the disk, check for scratches, and wipe it clean. Put the CD back inside and try again.
I can't play records
The record won't play/spin.
Check the needle covering
Check to see what the function on the device is set for. Make sure it is set for the "Phono" setting. Once confirmed, make sure the protective covering for the needle is removed.
Check the arm position
Move the arm to the right until you hear a click.
Band Functionality
The band inside the device may have stretched, snapped, or fell off. You will need to go inside the device in order to correct this. Click here for a guide on how to replace the turntable band.
Suspected Bad motor
In the event that you presume that the motor in your device is bad, manual repair will be necessary. Make sure that the trouble does lie in the motor however, some of the ways that you can check:
1.) Everything on the device lines up with standard operation of playing records. (Switches are in their correct position, device is set for "phono", etc.)
2.) The band inside the device is operational.
3.) The device lags when it starts to spin the record.
4.) The turntable does not keep constant speed.
5.) The record sometimes spins faster than it should. There is a significance difference in sound.
团队
Cal Poly, Team 1-38, Maness Winter 2014 Cal Poly, Team 1-38, Maness Winter 2014 的会员
CPSU-MANESS-W14S1G38
4 名成员
创作了5篇指南
54条评论
I am getting a crackle sound in the volume control knob Like it is not making a clean connection inside. What do you think?
Rodney A Lynam - 回复
If you’re still having this problem, try unplugging your record player and then turn the volume knob all around really quickly a bunch of times. It should clean out the grime on the contacts. I was having this problem and saw this solution on Lifehacker. It worked in my case!
Kelly S -
If you’re still having this problem, try unplugging your record player and then turn the volume knob all around really quickly a bunch of times. It should clean any grime of the contacts. I was having this problem and found this solution on Lifehacker. It worked in my case!
Kelly S -
My turntable won't turn, makes noise like it's trying but nothing
Joann - 回复
The cd opening will not open or eject , the display says no cd installed I can here it cycle but the cd door does not open i.e. Cannot load or play CDs
dave - 回复
CD door won’t open - hear a “clunky” noise, but nothing happens. How do I repair this?
S. Mink -
did any one get an answer???? It is 2020 and I still can’t get the CD to open
Carol Pickel -
My CD player door in my multifunction Crosley will not open .Display says no disc but door will not open and therefore I can't insert cd. I can hear it cycle when I press Open/close model CR 248
dave - 回复
Hi Rodney I am experiencing the same problem with my system as well. The sound gets cut off and play again and cut off... especially when I am playing my vynil...
I am getting a crackle sound in the volume control knob Like it is not making a clean connection inside. What do you think?
Rodney A Lynam - June 26
Bongani - 回复
My turntable has a very poor sound quality when I try to play the music a bit louder. It's kinda like a scratching sound. what could it be?
carolina - 回复
My cd door will not eject
mccraw_dan - 回复
Same issue think I put CD in wrong-side up. . .just "busy" comes up, doesn't play and doesn't eject WTF
Donald Boxley -
My CD function has started to skip on all the CD's -
311mom - 回复
I put in a CD, and it says 00 like nothing is in it. And I can't play the CD
Tom McSchwagger - 回复
Same issue, did you find a solution??
Maryfcanderson -
I’m experiencing the same issue. Did you find a solution??
Maryfcanderson -
Same problem
Luke Allen -
Adding to the list. Seems to be a common problem, and not seeing a solution
traciikunkel -
CD player does not work. Did all as mentioned in trouble shooting section. CD work on other systems.
Richard Z. mazewski - 回复
The standby light is on but when I push it actually pair with a unit on the light goes off and nothing will play nothing happens
Vivian Lee Thorpe - 回复
I bought the CROSLEY REcord player from HSN enjoyed every moment when I either listened to my favorite CD/Record or Tape. Unfortunately for the last 8months or so, the whole system has stopped entertaining me. Can I send this to your Repair department for a physical check and see how you can fix this for me.
Your help and service is greatly appreciated.
Thank you.
Agnes.
agnes joshiakar - 回复
Did they every reply to where you can take it for a repair?
Sue Harris -
I can get power to turn on.
Sue Harris - 回复
unit made in
Sue Harris - 回复
2011 made date.
where can I take it in Fort Wayne area?
Sue Harris - 回复
Hi, the power light only comes on when I turn the turntable manually,it was working fine at the weekend. Would a new belt help?
Thanks
jillcamlives - 回复
new belt wont stay on cr49
Larry Anderson - 回复
new belt wont stay on record player cr49
Larry Anderson - 回复
I see several questions yet no answers, does Crosley monitor this site or are they hoping we will help each other? I have a multi function Crosley that stopped working with in the year I bought it. I am disappointed and frustrated.
Alison Vertz - 回复
this unit CR42C-PA Manufactured June 2016 Just wont power up Blows FUSE
Alvin Townsend - 回复
My record button eon't stay in recording mide! The unit is at least 12 years old
Connie Taylor - 回复
My “ record button" won't stay in recording modr when burning a cassette to a CD! Unit is at least 10 years old!
Connie Taylor - 回复
My cd play will open and everything but it won’t recognize that a disc is in it, I’ve tried every cd I have and it still reads as 00
Sydney Harmon - 回复
Volume control knob has no low volume. When you turn it on , it’s starts out at high volume.
Greg - 回复
My Crosley record player won’t work new belt new plug it turns on but won’t spin any ideas only used it about 12 times
Barbara green - 回复
mine wont even come on at all
km692 - 回复
Mine won't power on either
Larry Roberson -
The light comes on but no function is working.
Also the cd will not eject. Please give me some idea of what is going on with my system.
Carolyn Ford - 回复
Fixed my CD player by putting in a new rubber band but now my crosley model cr42c won't turn on after I plugged everything back in what's wrong with it does anyone know?
gomezjos005 - 回复
My turntable is spinning faster than it should on any speed. What is the cause?
Chris Swedberg - 回复
The CD won't open or close. Reads 00. Making a humming noise. Motor noise.
sheryl chrissinger - 回复
Power button doesn't work, the stand by light is always on. Digital display not on.
Maurice Iahtail - 回复
Everything works.. but when I put a CD on I hear a whirring sound .. CD does play Nd noise lessens when music starts
Virginia Spaide - 回复
Radio issues-scratchy noises for the last couple of weeks, as if if it is not accurately tuned to the station/frequency; all radio stations, including local community stations affected; all these worked perfectly well previously
Charles - 回复
My CD won't play and now I can't get the CD player to open.
Brenda B - 回复
The lid won’t open is there a trick ?
klsroc - 回复
The thing just won’t turn on and I checked every power issue my phone charges in a place but the record player just stays off
Tony - 回复
Cannot get the CD player to play. It goes to 00 but thats all that happens.
patsylee4u - 回复
Sensor shows #060720. Can't get any control buttons to do anything.
Joyce Fowler - 回复
it will play the record and i get good sound. it will not go into the record mode to the cd. any advice please?
berniemings1970 - 回复
Radio stopped playing it came on suddenly one day for a minute and switched off again.
David Burch - 回复
Hello, my records play but not radio or Bluetooth. Suggestions?
Sonia Matthews - 回复
The radio and Bluetooth won't play but the record player does. Suggestions?
Sonia Matthew - 回复
My radio stopped playing FM stations and only a few AM stations can be heard. How do I fix this?
Raven
Raven Gregg - 回复