bryan clarke

Does anyone have a lead on a replacement battery supplier for this Samsung galaxy s8 active? Can not seem to locate a...

So I replaced the digitizer on an ipad air last night. I got it put together and powered it up and all seemed well. Once I...

I have repaired many iphone 4 screens and have not come across this problem. I changed the screen assembly and got the...

I asked this question a week ago and got no reply. Someone please help a brother out. I have an iPhone 4 that came in for...

I have an iPhone 4 gsm that goes into recovery mode after it dies. Apparently this happens every time. The phone is not...

When installing a new touch screen on an iPod touch 4g, what is the best way to go back on with the new screen? I have...

you mentioned changing the port but did you try a different set of buds?

I have been receiving email from elekworld supply that they have iPhone 6 parts available.

If they are available on the market I would venture to say that the screen will cost just about as much as buying a new TV. You may scout eBay,amazon or Craigslist for a used set that is identical to the one in question.

I can say with about 98% certainty that the new digitizer was not taped correctly at the bottom near the home button. If the tech did not get the whole bottom edge of the digitizer insulated it will act randomly. It is funny that it only happens in the small area but my money is on that area not being insulated.

Battery, charging port flex and the cellular antenna/speaker in closure have been changed with known good parts and no dice. It's down to a mobo problem. Does anyone know what chips to check for power management? We're is the pmu ic?

Im taking a shot in the dark here but sounds like a failed LCD or a loose connection. The only way to know for sure is to disassemble it and examine it for cable damage or loose connection and swap out lcd with a known good part to test theory.

Open it up and check if the LVDS (display data cable) is damaged or loose. Try a known good display data cable. If this fails replace the LCD.

disconnect the battery

Brand may be listed in about this apple. You will go to Apple menue, click the about this mac at the top of the drop down and click more info the system report then find SATA/SATA express on the list on the left. Buy fro OWC (macsales) they have their navigation set to compile a view of only drives compatible with your system. Hope this helps

I second the power cycle. Disconnect the battery or preform a hard reset to see if this remedies the issue.

What causes the boot loop after replacing the front camera flex? If I unplug it it works fine. New part boinked?