Eric

I have installed 2 new charge ports in an s8 and both are giving me a moisture in chargeport error. I even ultasoniced one...

I have had this issue a couple times with the iPad Air 2. One of the methods to fix this is to do a full DFU restore. Im not sure why this works but it has done on several occasions. Let me know how you get on. https://www.hardreset.info/devices/apple...-ipad-air-2-wi-fi/dfu-mode/

I see this a lot. Just because there is no visible water lest in the device doesn’t mean there isn’t a puddle under a shield. Water damage is a extremely time sensitive repair and you did the right thing by acting fast. Unfortunately the device needed a ultrasonic wash in isopropyl or acetone. Nail polish remover might have been a good option at the time. If the device has been sitting for a week with even a small amount of salt water id say she’s done. As a last ditch effort i would do an ultrasonic wash anyway. Replace the screen and battery and see if you have any life. Id also try a new charge port and if you have a current meter, test to see what the device is drawing from the wall. Hope this helps.

We replaced the whole frame and front LCD Assembly (one piece) and it started working. If you know why that helped please let me know

There isn’t any software as far as i’m aware. You can type *#0*# into the dial pad and use Samsungs QC tools.

If the device was water damaged the board should have been ultrasonic’d no matter what. Having the device on could be causing severe damage. Even if you cant see water doesn’t mean it hasn’t gone deep into the logicboard At this stage i would take the board out, ultrasonic. Use new components to test. Battery, screen, chargeport. Upside is that the home button might still work i guess..

This is very common in windows 10. I wasn’t happy when mine was doing this so i installed an SSD. Problem solved

This is a connection issue. Often when connecters are not seated properly (especially on the 5 series and SE) the screen displays bars. Id suggest removing the display, checking the connectors arnt damaged, clean the connectors with isopropyl and see how it goes from there. Also, make sure the cables are not getting twisted or stretched when laying the screen back down.

Put your imei into this website http://iphoneox.com/

This is the speaker assembly. If it was removed from the old one you will need it for the replacement MacBook Pro 13" Unibody Mid 2012 Left Speaker Replacement

There is a much higher fault rate on aftermarket parts. The reason these parts exsist is for lower price repairs. In the shop we only use originals for the i7 as the part is expensive as it is. Sending back many will be a massive hassle I would recommend getting an original screen from ifixit or other reputable supplier.

Life saver!!